Abstract:The optoelectronic properties of polythiophene (PT) graft block copolymers are most important for fabricating optoelectronic devices, and recently, we reported a single-pot atom-transfer radical polymerization (ATRP) technique for preparation of PT graft block copolymers between thermoresponsive poly(diethylene glycol methyl ether methacrylate) (PDEGMEM) and pH-responsive poly(dimethyl amino ethyl methacrylate) (PDMAEMA) from the PT backbone via the "grafting from" strategy with an 11 mol % contamination. A "grafting onto" strategy has been opted to eliminate the contamination from the block copolymer where we synthesized poly(thiophene acetic acid) (P3TAA) followed by the coupling with PDEGMEM-b-PDMAEMA-Cl, PDMAEMA-b-PDEGMEM-Cl, and PDMAEMA-ran-PDEGMEM-Cl copolymers, produced separately by the ATRP technique. The polymers were characterized using 1H NMR, SEC, etc. TEM study exhibits mostly vesicular morphology and optical properties measured using UV-vis and photoluminescence spectroscopy showing pH dependent behavior. dc conductivity values indicate semiconducting nature in the order P2 > P3 > P1. The abrupt hike of P2 (∼80 times) in conductivity at pH 3 from that of previously prepared P2 copolymers formed by the grafting from process is attributed to the absence of ∼11 mol % contamination. Conductivity decreases with increasing pH, due to coiling of the PT backbone in accordance with the blue shifts of λabs peaks. The current (I)-voltage (V) plots exhibit bimodal memory and organic mixed ionic and electronic conductivity. Higher current (3.3 mA for P2, pH 3) and electronic memory occur upon light irradiation than that of dark. Photoswitching property decreases with increase of pH, showing highest photocurrent gain of 8.05 for P2 at pH 3. Photocurrent gain follows the order P2 > P3 > P1 indicating P2 is the best to develop photoswitches in the P-series polymers. Fitting of growth and decay curves suggests that they are a two-stage process: photocurrent raises fast at the on state initially and then at a slower rate and similar at an off state. Impedance spectra suggest charge-transfer resistance and Warburg impedance values follow the order of P1 > P3 > P2, whereas capacitance value follows the opposite order.

Chemical and electrochemical grafting of polythiophene onto poly(vinyl chloride): synthesis, characterization, and materials properties

Chemical and electrochemical grafting of polythiophene onto poly(methyl methacrylate), and its electrospun nanofibers with gelatin

A New Polymerisation Route to Conjugated Polymers: Regio- and Stereoselective Synthesis of Linear and Hyperbranched Poly(Arylene Chlorovinylene)S by Decarbonylative Polyaddition of Aroyl Chlorides and Alkynes

Synthesis and characterization of poly(vinyl chloride)-g-poly (2-hydroxyethyl methacrylate) copolymers

Photo-induced Synthesis of PVC Macroinitiators and Preparation of Amphiphilic Graft Copolymers

Electrocatalytic Grafting of Polyvinyl Chloride Plastics

Structure-property relationships of lightly chemical crosslinked poly(vinyl chloride) thermoplastic elastomer

Thienyl Chloride Initiated Living Cationic Polymerization: A General and Efficient Access Toward Terminally Functionalized Poly(vinyl Ether)s

Synthesis of a Soluble Polythiophene Copolymer with Thiophene–vinylene Conjugated Side Chain and Its Applications in Photovoltaic Devices

Novel Electrochromic Copolymers Based on Thiophene-Anthracene Derivatives Via Electrochemical Polymerization in Boron Trifluoride Diethyl Etherate

Synthesis and Application of Conducting Graft Copolymer with Viable Processability

Synthesis, characterization of polyvinyl chloride -graft-4-Amicacid phenol and application of adsorption for lead ion

Synthesis of a Terpolymer Containing Fluorene, Side Chain Conjugated Thiophene and Benzothiadiazole and Its Applications in Photovoltaic Devices

Direct Functionalization of Poly(vinyl Chloride) by Photo-Mediated ATRP Without a Deoxygenation Procedure

Synthesis of poly(vinylidene fluoride-co-chlorotrifluoroethylene)-g-poly(methyl methacrylate) with low dielectric loss by photo-induced metal-free ATRP

On the Electrochemical Properties of Poly(Vinylidene Fluoride)/Polythiophene Blends Doped with Lithium‐Based Salt

Synthesis Internal-Plasticized PVC Copolymer Resin from Industrial Application View: Copolymerization of Vinyl Chloride with Poly(ethylene Glycol) Monomethyl Ether Methacrylate Via Suspension Polymerization

A facile approach to surface graft vinyl acetate onto polyolefin articles

Enhanced Optoelectronic Properties of Polythiophene- g-Poly(dimethyl amino ethyl methacrylate)- b-Poly(diethylene glycol methyl ether methacrylate) Copolymers using " Grafting onto" Synthetic Strategy

Facile Grafting Modification of Poly(Vinylidene Fluoride‐ Co ‐trifluoroethylene) Directly from Inner CHCH Bonds

Unsubstituted Polythiophene Film Deposited via In-Situ Sequential Solution Polymerization for Chemo-/Electrochromism