Abstract:This work focuses on co-pyrolysis experiments of Utah Sufco coal with linear low-density polyethylene (LLDPE) and high-impact polystyrene (HIPS). These two plastic types have differing pyrolysis chemistries and have different hydrogen transfer behavior. Similar to earlier work in this series of papers, controlled secondary gas-phase reactions during pyrolysis were used to induce cracking and condensation reactions among the pyrolytic tar species. Co-pyrolysis tests were performed with feed plastic percentages ranging from 10 to 20 wt % and pyrolysis SGR temperatures ranging from 800 to 900° C. Analyses of the intermediate tar products showed that oxygen contents and aromaticity were substantially different, depending on the plastic, and resulting pitch softening points and mesophase contents also varied greatly depending on the starting plastic feedstock used. Most of the synergies observed in the co-pyrolysis results were negative, except for the oxygen content. Oxygen contents were higher than expected when LLDPE was used, resulting in reactive pitches with softening points >350° C. On the other hand, oxygen contents were lower than expected when HIPS was used, resulting in less reactive pitches. Ultimately, only the HIPS/coal samples created at the SGR temperature of 900° C had reasonable softening points at or under 350° C, making them the only samples created in this work potentially suitable for mesophase pitch-based carbon fiber production. The success in creating fusible mesophase pitches from co-pyrolyzing HIPS with Utah Sufco coal is likely attributed to the fact that polystyrene is a stronger hydrogen acceptor rather than donor, which should facilitate more cracking rather than stabilizing tar oxygen functional groups, making the tar species ultimately less reactive during thermal conversion to mesophase pitch.

Preparation of plastic anisotropic pitches from products of heat treatment of heavy tar from pyrolysis of hydrocarbon raw materials

Effect of secondary gas-phase reactions (SGR) in pyrolysis of carbon feedstocks for anisotropic carbon materials production – 3: Modifying non-coking coal tar through co-pyrolysis of coal with linear low-density polyethylene and high-impact polystyrene

Structure and composition of mesophase pitch prepared from aromatic‐rich fluid catalytic cracking slurry under different process conditions

An Investigation of the Preparation of Coal Tar- and Petroleum-Based Pitch Spheres and Their Oxidation Stabilization

Application of TGA in the Study of Refined Coal-tar Pitch

Exploration of fibers produced from petroleum based-mesophase pitch and pet blends for carbon fiber production

STUDY ON THE OXIDATIVE STABILIZATION OF PITCH SPHERES

Evaluating of the oxidative behaviors of isotropic pitch fractions for optimal the mechanical properties of isotropic pitch-based carbon fibers

Effect of isopropyl chloride addition in AlCl 3 catalytic system on the formation of coal tar pitch-based mesophases

Hydrogenation Behaviors and Structural Variations of Subfraction of Coal Tar Pitch and Preparation of Mesophases with Well-Developed Optical Textures

Preparation of Isotropic Carbon Fibers from Kerosene-Purified Coal Tar Pitch by Co-Carbonization with Pyrolysis Fuel Oil

Synthesis and Structural Evolution of Coal-Based Mesophase Pitch by Hydrogenation-Vacuum Thermal Polycondensation Process

Preparation and characterization of pitch coke from oxidized polymerized pitch

Preparation of Mesophase Pitch with Fine-Flow Texture from Ethylene Tar/Naphthalene by Catalytic Synthesis for High-Thermal-Conductivity Carbon Fibers

Reformation of Naphtha Cracking Bottom Oil for the Preparation of Carbon Fiber Precursor Pitch

Kinetic study of mesophase transformation of coal tar pitches by programmed heating

Preparation and Characterization of High Softening Point and Homogeneous Isotropic Pitches Produced from Distilled Ethylene Tar by a Novel Bromination Method

Optimizing Aromaticity for Graphitization

Study of the Viscosity and Thermal Characteristics of Polyolefins/Solvent Mixtures: Applications for Plastic Pyrolysis

Modified effect on properties of mesophase pitch prepared from various two-stage thermotreatments of FCC decant oil

Effective Preparation of Mesophase by Segmented Hydrogenation/Thermal Polycondensation of Coal Liquefied Pitch