Abstract:BackgroundControlled low strength materials (CLSM), known as flow able fill is used as a replacement of compacted soil in cases where the application of the latter is difficult or impossible. The low mechanical requirements compared with concrete enable the use of industrial wastes for the production of CLSM. In general, CLSM mixtures consist of standard materials such as Portland cement, fly ash, fine aggregate and water. However, other industrial by-products and recycled materials are also accepted and encouraged as long as they are considered to be available, cost-effective for specific application and the necessary characteristics of the mixture such as flowability, strength, excavatability, and density are acceptable.MethodsThe aim of this study is to evaluate the feasibility of incorporating red mud as a partial replacement for Portland cement into a controlled low-strength material (CLSM) made by industrial by-products (e.g., ponded ash and fly ash). A control mixture was initially produced with ponded ash, Portland cement, Class F fly ash, and water. For other mix proportions, red mud was substituted for Portland cement in amounts of 5, 10, 15, 20, 25, and 30 % by weight. The bleeding, flowability, fresh density, initial setting time of fresh CLSM mixtures were measured and the follows were hardened ones including compressive strength, corrosivity.ResultsExpectedly, all general properties of CLSM incorporating red mud did fall within the acceptable ranges. They performed well and conformed to the requirements of CLSM in ACI 229 standards with regard to flowability, bleeding rate, initial setting time, corrosivity and unconfined compressive strength.ConclusionsThe partial replacement of cement by red mud, possibly up to 30 % in mixtures, would reduce flowability and slightly increase corrosivity evidenced by pH but still meet the requirements. Especially, it was found that an increase in red mud content could lead to an improvement in the stability (bleeding rate) and accelerate the setting process on the performances of the proposed CLSM. Finally, with regard to strength at 28 days, CLSM with highest strength could be produced by an optimum replacement of 15 % red mud to cement. In overall, it is worth noting that red mud could be feasible and potential in use as a partial replacement to Portland cement in CLSM production.

Chemical and environmental compatibility of red mud liners for hazardous waste containment

Effects of Red Mud on Workability and Mechanical Properties of Autoclaved Aerated Concrete (AAC)

Material properties and environmental implications of red mud solidified with blast-furnace slag, silica fume, and sodium hydroxide

Experimental Investigation on Red Mud from the Bayer Process for Cemented Paste Backfill

A Detailed Geotechnical Investigation on Red Mud and Chemical Analysis of Its Leachate

Applications of red mud as an environmental remediation material: A review

Environmental Safety Analysis of Red Mud-Based Cemented Backfill on Groundwater

Assessing the potential of red mud and dehydrated mineral mud mixtures as soil matrix for revegetation

Reuse of red mud in construction of tailing dam

Solidification Mechanism of Bayer Red Mud under the Action of Calcium Hydroxide

Synthesis and characterization of new acid-activated red mud-metakaolin geopolymers and comparison with their alkaline counterparts

Leaching Kinetics and Reactivity Regulation of Red Mud in an NaOH Solution

Clean dealkalization technology from aluminum industry hazardous tailings—red mud by displacement with Mg-based agent

Research Enhancing Acidic Mine Wastewater Purification: Innovations in Red Mud–Loess

Alkali-activated red mud in stabilizing marine dredged clay with low amount of cement

Hydrothermal chemical modification of red mud for efficient adsorption of methylene blue

A review of comprehensive utilization of red mud

A STATE OF ART AND PROSPECTS OF RED MUD MANAGEMENT

The synergistic hydration mechanism and environmental safety of multiple solid wastes in red mud-based cementitious materials

Staged leaching behavior of red mud during dealkalization with mild acid

Engineering properties of controlled low strength material (CLSM) incorporating red mud