Abstract:Meso-structural models are presently in common use for analysis of the mechanical behaviour, damage evolution and failure of concrete. These are constructed either from XCT images, or in silico, using statistical information about concrete's meso-scale constituents. As a minimum, such models include mortar and aggregates as separate phases, while more detailed versions consider the interfacial transition zones (ITZ) between mortar and aggregates, and voids. Analyses of given meso-structures vary further by different constitutive modelling of constituents, with past works focusing on parameters' calibration using experiments with one loading condition - either tension or compression. Using a detailed meso-structure representation, this work proposes a novel combination of constitutive relations, involving concrete damage plasticity (CDP) for mortar and cohesive zone behaviour for ITZ. CDP parameters are calibrated using both compression and tension experiments with mortar samples. ITZ parameters are calibrated by comparing simulated stress–strain curves and failure patterns with data from compression and tension experiments with concrete samples. This process leads to constitutive relations, applicable to both loading conditions, which has not been demonstrated previously, but is essential to extending the modelling approach to complex stress states encountered in real engineering structures. After establishing the realism of the approach, parametric studies are conducted to investigate the effects of friction between loading plate and specimen, the mortar dilation angle, the ITZ cohesive stiffness, critical stresses, fracture energy and mix mode ratio. The results show that mortar plasticity is the dominant energy dissipation mechanism in both compression and tension, and its rate governs the localisation of damage. The effect of ITZ parameters on the tensile behaviour is found to be negligible. Their effect on the compressive behaviour is found to be limited, but sufficient to propose a set of parameters working for both conditions. Importantly, under both loadings the ITZ is found to control failure localisation into a macroscopic crack in combination with mortar plasticity and damage. Predicted stress-stain curves, damage evolution and macro-crack propagation are shown to be in very good agreement with the experimental observations. This justifies the use of the proposed experimental-modelling strategy for developing models for analysis of complex loading conditions.

Calibration of a concrete damage plasticity model used to simulate the material components of unreinforced masonry reinforced concrete infill frames

Calibration of a New Concrete Damage Plasticity Theoretical Model Based on Experimental Parameters

About the Use of Concrete Damage Plasticity for Modeling Masonry Post-Elastic Behavior

Experimental and numerical investigation of mortar and ITZ parameters in meso-scale models of concrete

Slip-enhanced plastic-damage constitutive model for masonry structures

Simulation of Masonry Wall using Concrete Damage Plasticity Model

Damage Based Constitutive Model for Predicting the Performance Degradation of Concrete

An improved damage-plasticity material model for concrete subjected to dynamic loading

A robust computational strategy for failure prediction of masonry structures using an improved multi‐surface damage‐plastic based interface model

3 D In-situ XCT Image Based Mesoscale Fracture Modelling and Validation of Concrete Using Voxel Hexahedron Meshing and Damage Plasticity Model

A plastic-damage model for concrete

Numerical and Experimental Investigation on Cyclic Behavior of Masonry Infill Walls Retrofitted with CFRP

Evaluation of Compressive and Tensile Stress–Strain Parameters of Concrete Damage Plasticity Model for Concrete Slabs Under Impact load

Effective Prediction of Concrete Constitutive Models for Reinforced Concrete Shear Walls under Cyclic Loading

A machine learning based material homogenization technique for in-plane loaded masonry walls

CONCRETE DAMAGE PLASTICITY MATERIAL MODEL PARAMETERS IDENTIFICATION

Damage plasticity model for green concrete material

A Coupled Plastic Damage Model for Concrete considering the Effect of Damage on Plastic Flow

In-Plane Lateral Response of a Full-Scale Masonry Subassemblage with and without an Inorganic Matrix-Grid Strengthening System

3D hybrid modelling approach combining the finite and discrete element methods: Validation based on masonry shear wall tests

A methodology for parameter identification and calibration of the cohesive element based meso-scale concrete model