Abstract:Abstract Development and exploitation of oil and gas resources in increasingly difficult operating environments such as deepwater raise many technical challenges. Among these is the ability to provide assurance on the completions and production from high-cost and complex wells. Real-time, permanent wellbore and reservoir monitoring is a critical technology for providing assurance and maximizing profitability of these fields. Recent developments in fiber optic sensing technology have resulted in reliable alternatives to conventional electronic systems for permanent, downhole production and reservoir monitoring. In-well fiber optic sensors are now being developed and deployed in the field for measuring temperature, pressure, flow rate, fluid phase fraction, and seismic response. Bragg grating-based fiber optic systems combine a high level of reliability, accuracy, resolution and stability with the ability to multiplex sensors on a single fiber, enabling complex and multilateral wells to be fully instrumented with a single wellhead penetration. These systems are being installed worldwide in a variety of operating environments for a variety of applications. This paper presents several recent deployments of in-well fiber optic monitoring systems, including descriptions of the downhole sensor assemblies, installations, and measured data. Installations of fiber optic pressure and temperature systems in a land well and in the Gulf of Mexico and an all-fiber flow and liquid fraction system in deepwater Gulf of Mexico are discussed. A general description of fiber optic sensing and Bragg grating-based sensing systems is also presented. Introduction The past several years have seen a great increase in the development, deployment and application of permanent in-well monitoring systems. Drivers behind this increase include new field developments in much more challenging, costly operating environments; the requirement to provide assurance on the production from these new fields; and the desire to optimize management of production and reservoir recovery. Cost. Many large, new fields coming on line today and in the near future are being developed with relatively few high-cost, high-rate, complex wells. Intervention costs in these wells will be high or even prohibitive. This puts a premium on the value of real-time downhole data during production and on the use of this data to foresee and prevent well problems. Assurance. The large, up-front capital investment for many new field developments, such as deepwater, puts a tremendous importance on the assurance of producing the anticipated volumes of oil and gas in the anticipated timeframe, in order to make the required return. Downhole monitoring systems provide data to continuously assess the health of the well, optimize well operations, and provide assurance on the flow of oil and gas. Optimized Production and Reservoir Management. Real-time downhole data offer many opportunities to greatly improve production management and reservoir recovery. These include actively managing drawdown to increase production performance; production and injection profiling in horizontal and multi-zone wells to identify and control fluid flow to and from different parts of the well; providing sufficient information to allow for the early determination and confirmation of reserves; allowing for active reservoir management early in the field life; optimizing drainage; and increasing overall field recovery. In most, if not all cases, the value derived from real-time, downhole monitoring systems greatly exceeds the cost and can be recovered early in the life of the well, IF these systems are reliable and perform as specified over the life of the well and IF the data are managed properly and used to their fullest potential. Fiber optic-based sensing systems being deployed today offer the promise of achieving the level of performance required to achieve this value.

Evaluating Stimulation Effectiveness with Permanent Optical Fiber and Sealed Wellbore Pressure Monitoring: Bakken Case Study

Initial 3-C–2D Surface Seismic and Walkaway VSP Results from the 2015 Brooks SuperCable Experiment

One Stage Forward or Two Stages Back, What are We Treating? Identification of Internal Casing Erosion During Hydraulic Fracturing - A Montney Case Study Using Ultrasonic and Fiber-Optic Diagnostics

Interpretation of Fracture Initiation Points by In-Well Low-Frequency Distributed Acoustic Sensing in Horizontal Wells

Diagnosing Multistage Fracture Treatments with Distributed Fiber-Optic Sensors

The Optic Oil Field: Deployment and Application of Permanent In-well Fiber Optic Sensing Systems for Production and Reservoir Monitoring

Estimation of Far-Field Fiber Optics Distributed Acoustic Sensing DAS Response Using Spatio-Temporal Machine Learning Schemes and Improvement of Hydraulic Fracture Geometric Characterization

Quantitative Analysis of Hydraulic Fracturing Test Site 2 Completion Designs Using Crosswell Strain Measurement

Testing of a Permanent Orbital Surface Source and Distributed Acoustic Sensing for Monitoring of Unconventional Reservoirs: Preliminary Results from the Eagle Ford Shale

Fracture Hits and Hydraulic-Fracture Geometry Characterization Using Low-Frequency Distributed Acoustic Sensing Strain Data

Well-scale demonstration of distributed pressure sensing using fiber-optic DAS and DTS

Downhole Surveillance During the Well Lifetime Using Distributed Temperature Sensing

Thermal Effects on Far-Field Distributed Acoustic Strain-Rate Sensors

Interpretation of low-frequency distributed acoustic sensing data based on geomechanical models

Multiphysics monitoring of cementation operation: implications for wellbore integrity and hydrogeological characterization

Fracture-Hit Detection Using LF-DAS Signals Measured during Multifracture Propagation in Unconventional Reservoirs

Fluid and Proppant Distribution and Fracture Geometry Calibration Using Permanent Fiber-Optic Sensing DAS/DTS – Oman Case Study

Experimental Investigation of Low-Frequency Distributed Acoustic Sensor Responses to Two Parallel Propagating Fractures

New High-Frequency Pressure Monitor Algorithm Guided Multistage Stimulation for Long Lateral Without Mechanical Isolation

Using distributed acoustic sensing to characterize unconventional reservoirs via perforation-shot triggered P waves

Experimental Investigation of Low-Frequency Distributed Acoustic Strain-Rate Responses to Propagating Fractures