Slat Noise: Aeroacoustic Beamforming in Closed-Section Wind Tunnel with Numerical Comparison

Carlos C. Pagani,Daniel S. Souza,Marcello A. F. Medeiros
DOI: https://doi.org/10.2514/1.j054042
IF: 2.624
2016-07-01
AIAA Journal
Abstract:Experiments in closed-section wind tunnels are more suitable for comparisons with numerical results than corresponding experiments in open-section tunnels because well-defined boundary conditions far from the model can be established for the numerics. This paper reports acoustic experimental results on the slat region of a two-dimensional high-lift model. An objective was the production of experimental data to be used in the testing of numerical procedures. Conventional beamforming combined with a deconvolution technique was used. The Reynolds number was approximately 1 million, whereas Mach number and angle of attack ranged from ~0.07 to ∼0.1 and 2 to 10 deg, respectively. To prevent interaction between wind-tunnel-wall boundary layers and the model, which causes undesirable three-dimensionality, suction was applied on the wind-tunnel walls, and its effect was investigated. Experimental results for two angles of attack were compared with computational results given by a lattice–Boltzmann solver for the validation of the experimental procedure based on side-wall suction and deconvolved source map computations. The results agreed, in particular regarding the dominant parts of the spectra, and were considered a cross validation of both experimental and numerical approaches. The numerical results were used in the characterization of the flow in the slat cove.
engineering, aerospace
What problem does this paper attempt to address?