Abstract:PDC drill bit performances in hard rock has been greatly improved during the last decades by innovations in PDC wear, impact resistance and better vibrations understanding. The bit design is generally done by balancing the bit, distributing uniform wear along the profile and achieving high drillability and steerability. To obtain required drilling performances, drill bit designer adjust features such as profile shape, gage and mainly cutter characteristics (shape, type and orientation). Cutter rock interaction model became a critical feature in the design process. But previously used models considered only three forces on a cutter based on the cutter-rock contact area : drag force, normal force and side force. Such models are no longer valid with the introduction of PDC cutters with chamfer and special shape. This paper presents a new cutter rock interaction model including some several improvements. It is based on the presence of a build-up edge of crushed materials on the cutting face often described in the literature. In addition, the chamfer, which significantly affects bit Rate Of Penetration (ROP), is taken into account (shape and size). Forces applied on the back of the cutter and due to the rock deformation and back flow of crushed materials are considered in the model. Finally, results of numerous single cutter tests (under atmospheric and confining pressure) are presented and compared to the new cutter rock interaction model predictions. An analysis of the influence of the PDC characteristics (shape, size, chamfer, back and side rake angles, ....) is presented. The model has been applied to optimize the cutting efficiency and bit steerability and some design rules are given to minimize the specific energy and maximize the rate of penetration. Finally, full scale laboratory drilling tests and field results indicate that the use of accurate cutter rock interaction model can help the drill bit designer to find the best drill bit for a specific application. Standard laboratory full scale drilling procedures have been developed. The tests have shown that drillability, stability, steerability and wear can be improved and controlled by acting on the cutter characteristics, cutter setup, trimmer characteristics and gage type.

Rock Drilling Performance Evaluation by an Energy Dissipation Based Rock Brittleness Index

Experimental and theoretical analysis of rock failure characteristics by a single PDC cutter under downhole pressurized conditions

Characterizing Rock-Breaking Performance of PDC Cutters via Stability Metrics and Energy consumption in FDEM Simulations

Rock Strength Determination Based on Rock Drillability Index and Drilling Specific Energy: Numerical Simulation Using Discrete Element Method

The PDC cutter-rock interaction behavior in rock cutting: A review

Research on rockburst proneness evaluation based on interpretation of drilling parameters

Numerical investigations on rock breaking mechanism and parameter influence of torsional percussive drilling with a single PDC cutter

Evaluating the Anisotropy of Drilling Mechanical Characteristics of Rock in the Process of Digital Drilling

Drilling Process Monitoring for Predicting Mechanical Properties of Jointed Rock Mass: A Review

Determination of Internal Friction Angle of Rocks Using Scratch Test with a Blunt PDC Cutter

Numerical Investigation of the Effect of Pre-induced Cracks on Hard Rock Cutting Using Finite Element Analysis

Fragmentation Characteristics of Rocks Under Indentation by a Single Polycrystalline Diamond Compact Cutter

Rock breaking mechanism in percussive drilling with the effect of high frequency torsional vibration

Experimental investigation of the rock cutting process and derivation of the 3D spatial distribution of the formation strength using in-cutter sensing

An experimental and numerical investigation on rock cutting behavior of specially-shaped PDC cutter

Analysis of Rock Dynamic Stresses During the Drilling by Polycrystalline Diamond Compact Bits

Modelling and Mechanical Characteristics of PDC Cutter-Rock Interaction by Combining Mixed Fragmentation Modes with Dynamic Rock Strength

Performance analysis of drilling machines based on rock properties and machine's specifications

Prediction of formation abrasiveness under the action of a PDC bit based on the fractal dimension of a rock surface

PDC Bits: All Comes From the Cutter/Rock Interaction

Numerical investigation on rock‐breaking mechanism and cutting temperature of compound percussive drilling with a single PDC cutter