Abstract:With an interest in developing and studying the stability of laminar undisturbed basic-state solutions, this work is focused on accurately modeling the laminar flowfield of the boundary layer transition (BOLT) geometry under nominal and off-nominal conditions (i.e., nonzero angles of pitch and yaw). The BOLT flowfield is studied using the DPLR flow solver with MUSCL Steger–Warming fluxes using a set of five grids at different resolutions and identical grid topologies. A total of three different sets of conditions are studied: two flight conditions and one wind-tunnel-scale (33%) condition. (1) For the two sets of nominal flight operating conditions, it is found that the flow structures in the centerline region of BOLT are similar to those found in prior studies including in shape, location, and extent both vertically and spanwise, but a detailed comparison of velocity contours shows that further quantitative convergence studies are warranted. The centerline region, however, extends to at most 4 cm in semi-span at the aft end of the geometry (20% of the semi-span). Away from the centerline and where wind-tunnel-scale results have observed regions of possibly transitional behavior, the laminar flowfield converges with high accuracy. (2) For nominal wind-tunnel operating conditions, all grid resolutions simulated show good agreement in most regions as compared with prior results, with any differences falling within the scatter of existing experimental and DNS results. Aside from this focus, boundary-layer stability is examined outboard of the centerline region at nonzero pitch and yaw for a flight case, and second mode and stationary crossflow instabilities are considered. Second-mode instability is found to be locally significant at certain pitch and yaw angles particularly downstream of the swept leading edges. In addition, stationary crossflow is found to become highly amplified in significant wedges extending to the aft end of the BOLT geometry, with N-factors consistent with those found for HIFiRE-5b associated with transitional flow. The reasons for amplification of these different instabilities are also investigated from a physics-based perspective.

Transient growth analysis of hypersonic flow over an elliptic cone

Computation of Hypersonic Transitional Flows Over Cones Using Gas-Kinetic Scheme Coupled with the Turbulence Model

Application of simplified threeGequation transition model in hypersonic flow

Non-modal growth analysis of high-speed flows over an inclined cone

Nonlinear coupled constitutive relations model and its applications

Computation of Hypersonic Flows over Flying Configurations Using a Nonlinear Constitutive Model

Global stability analysis of a hypersonic cone-cylinder-flare geometry

Accurately Predicting Hypersonic Transitional Flow on Cone Via a Symmetry Approach

Computational modeling and stability analysis of BOLT hypersonic geometry including off-nominal conditions

Loss of Axial Symmetry in Hypersonic Flows over Conical Shapes

Nonlinear Evolution of Instabilities in a Laminar Separation Bubble at Hypersonic Speeds

Newly Identified Principle for Aerodynamic Heating in Hypersonic Flows

Transient growth mechanisms of low Reynolds number flow over a low-pressure turbine blade

A Symmetry-Based Length Model for Characterizing the Hypersonic Boundary Layer Transition on a Slender Cone at Moderate Incidence

Numerical Computation and Flowfield Analysis of Hypersonic Flow over a Double-Cone Body

A Modular RANS Approach for Modeling Hypersonic Flow Transition on an Air-Breathing Configuration

Crossflow Instability on a Swept Fin–Cone with Variable Nose Bluntness in Mach 6 Flow

The Transient Start of Supersonic Jets

Secondary Instability of the Hypersonic High-Enthalpy Boundary Layers with Thermal–chemical Nonequilibrium Effects

Understanding the instability-wave selectivity of hypersonic compression ramp laminar flow

On linear stability of supersonic flow over a short compression corner at large ramp angles