Abstract:Conditions and systems for on-line combustion of effluents from capillary gas chromatographic columns and for removal of water vapor from product streams were tested. Organic carbon in gas chromatographic peaks 15 s wide and containing up to 30 nanomoles of carbon was quantitatively converted to CO2 by tubular combustion reactors, 200 x 0.5 mm, packed with CuO or NiO. No auxiliary source of O2 was required because oxygen was supplied by metal oxides. Spontaneous degradation of CuO limited the life of CuO reactors at T > 850 degrees C. Since NiO does not spontaneously degrade, its use might be favored, but Ni-bound carbon phases form and lead to inaccurate isotopic results at T < 1050 degrees C if gas-phase O2 is not added. For all compounds tested except CH4, equivalent isotopic results are provided by CuO at 850 degrees C, NiO + O2 (gas-phase mole fraction, 10(-3)) at 1050 degrees C and NiO at 1150 degrees C. The combustion interface did not contribute additional analytical uncertainty, thus observed standard deviations of 13C/12C ratios were within a factor of 2 of shot-noise limits. For combustion and isotopic analyses of CH4, in which quantitative combustion required T approximately 950 degrees C, NiO-based systems are preferred, and precision is approximately 2 times lower than that observed for other analytes. Water must be removed from the gas stream transmitted to the mass spectrometer or else protonation of CO2 will lead to inaccuracy in isotopic analyses. Although thresholds for this effect vary between mass spectrometers, differential permeation of H2O through Nafion tubing was effective in both cases tested, but the required length of the Nafion membrane was 4 times greater for the more sensitive mass spectrometer.

Separation of isotopes of nitrogen and oxygen by low temperature distillation of nitrogen oxide.

A Chemical Exchange System for Isotopic Feed to a Nitrogen and Oxygen Isotope Separation Plant

Separation And Stable Isotopic Measurement Of Lithium In Atmosphere Aerosol Sample

Experimental study of nitrogen isotope separation by ion-exchange chromatography: effect of process factors

Condensation Separation of NO 2 with Dimerization Reaction in the Presence of Noncondensable Gas: Critical Assessment and Model Development

Removal of tritiated water molecules by isotope exchange reaction between H2O vapor and tritium water

Steady-State Simulation of Cryogenic Distillation used for Helium Isotope Separation

Adsorption separation of heavier isotope gases in subnanometer carbon pores

Experimental Study on the Condensation Characteristics of Nitrogen with Non-Condensable Gas

Isotopes Separation Method using Physical Vapor Deposition Technique

Vapor–Liquid Equilibrium for the Mixture Nitrogen (N2) + Methane (CH4) in the Temperature Range of (110 to 125) K

Water Distillation as a Method for Separation of Hydrogen and Oxygen Isotopes: State of the Art and Prospects

Preparative Isotachophoretic Analyser Equipped with a Dropwise Fractionating Device

Optimization of Liquid Phase Catalytic Exchange Process for Hydrogen Isotope Separation Using Orthogonal Experiment Design

High enrichment of 15N by chromatographic chemical process.

Simulation for Separation of Oxygen and Nitrogen from Air

High Enrichment of 15N Isotope by Ion Exchange for Nitride Fuel Development

A stable nitrogen isotope pretreatment method for different forms of nitrogen in sewage

Low blank sampling method for measurement of the nitrogen isotopic composition of atmospheric NOx

Performance and optimization of a combustion interface for isotope ratio monitoring gas chromatography/mass spectrometry

Preliminary assessment of stable nitrogen and oxygen isotopic composition of USGS51 and USGS52 nitrous oxide reference gases and perspectives on calibration needs.