Abstract:The silicon vertex detector (SVD) is a four-layer double-sided strip detector installed at the heart of the Belle II experiment, taking data at the high-luminosity B -Factory SuperKEKB since 2019. SVD has been operating smoothly and reliably, showing a stable and above-99% hit efficiency, and a large signal-to-noise ratio in all sensors. In June 2022 the data-taking of the Belle II experiment was stopped for the Long Shutdown 1, primarily required to complete the vertex detector (VXD) with the inner two-layer DEPFET detector and to upgrade several components of the accelerator. This article reports on the excellent performance of SVD in terms of the signal-to-noise ratio, the hit position resolution, as well as the hit-time resolution. We briefly describe the challenges and delicate phases of the VXD re-installation and the SVD status for operation starting in early 2024. In SVD layer 3, which is closest to the interaction point, the average occupancy has been less 0.5%, well below the estimated limit for acceptable tracking performance. However, higher machine backgrounds are expected at increased luminosity, and so also increased hit occupancy. To enhance the robustness of offline software in a high-background environment, new algorithms of background suppression using the excellent SVD hit-time information have been developed, which allows a significant reduction of the fake rate, while preserving the tracking efficiency. With the increasing luminosity also the radiation levels are expected to increase, with possible deterioration of the sensor performance. The SVD integrated dose is estimated by the correlation of the SVD occupancy with the dose rate measured by the diamonds of the radiation monitor and beam-abort system. The effects of radiation damage are starting and in good agreement with our expectations. So far, no harmful impact due to the radiation damage on the detector performance has been observed.

The Belle II DEPFET vertex detector: current status and future plans

DEPFET pixels as a vertex detector for the Belle II experiment

DEPFET Active Pixel Sensors for the Belle II Experiment

Super KEKB and Belle II: Status of the KEK Super B Factory

DEPFET Vertex Detectors: Status and Plans

Upgrade of Belle II vertex detector with CMOS pixel technology

The Belle II Upgrade Program

Silicon Vertex Detector of the Belle II Experiment

The Belle II Detector Upgrades Framework Conceptual Design Report

Status of Belle II experiment before the first beams

Belle II Executive Summary

Belle II prospects for CP-violation measurements

A TPC-based tracking system for a future Belle II upgrade

The Belle Ii Pixel Detector Data Acquisition And Reduction System

Recent results from Belle and Belle II

Design of the OBELIX monolithic CMOS pixel sensor for an upgrade of the Belle II vertex detector

Belle II status and prospects for studies of neutral currents

Measured and projected beam backgrounds in the Belle II experiment at the SuperKEKB collider

The Monitoring System of the End-Cap Calorimeter in the Belle II experiment

The silicon vertex detector of the Belle II experiment