Abstract:Although end-bearing energy pile foundations subjected to symmetrical thermal cycles have been extensively studied in the laboratory and in the field, the mechanisms underlying the thermo-hydro-mechanical (THM) interactions in floating energy pile groups and rafts, especially when subjected to asymmetrical thermal loads, are not well understood. In this study, an advanced thermo-mechanical bounding surface model was implemented in finite-element (FE) code to investigate the THM interactions of a two-by-two floating energy pile group and pile raft, focusing on asymmetrical thermal cycles. Computed results are compared with published centrifuge model test results in soft clay. It is revealed that the irreversible volumetric contraction of the soil adjacent to the energy piles accumulates with each thermal cycle, resulting in a decrease in the horizontal stress and hence shaft resistance of the floating piles. During thermal cycles, the stress states of the soil around the energy pile shaft and the soil beneath the pile toe approach the critical state line along different paths. The induced temperature in the soil adjacent to the non-energy pile (NEP) is 5°C lower than that in the soil at the energy pile EP1, which is flanked by the other two energy piles EP2 and EP3. Consequently, the induced excess pore pressure in the soil at the NEP is approximately 20% smaller than that in the soil at EP1. The irreversible volumetric soil contraction at the NEP is about half that at EP1, resulting in approximately 45% less toe settlement. The thermally induced ratcheting settlements of the head and toe of the NEP are less than those of the energy piles, resulting in unacceptable ratcheting tilting of the floating energy pile group. However, the excessive tilting can be reduced by the use of a pile raft.

A thermo-mechanical model for pile-soil interface behavior

A constitutive model for thermal consolidation with vertical drains and its experimental verification

An Improved Model for the Horizontal Dynamic Response of Piles in Saturated Soil

A thermo-mechanical model for saturated and unsaturated soil-structure interfaces

A Study on the Softening Shear Model of the Energy Pile–Soil Contact Surface

Seismic Pile–Soil Interaction Analysis Based on a Unified Thixotropic Fluid Model in Liquefiable Soil

FEM Analysis and Simplified Approach for a Single Energy Pile Subjected to Thermomechanical Loads

Shear characteristics of interface based on subloading-friction model

Thermally induced mechanical interactions of energy pile groups subjected to cyclic nonsymmetrical thermal loading

Soil-structure Interface Modeling of Pile-Soil Interaction with an Elasto-Plasticity Damage Model

An Elasto-Plastic Numerical Analysis of THM Responses of Floating Energy Pile Foundations Subjected to Asymmetrical Thermal Cycles

Effects of Thermal Cycles on Soil Behaviour: Theoretical and Experimental Studies

Constitutive modeling of soil-structure interface through the concept of critical state soil mechanics

A critical state three-dimensional multi-shear model for soil-structure interfaces under monotonic and cyclic loading

A Thermodynamic Constitutive Model for Undrained Monotonic and Cyclic Shear Behavior of Saturated Soils

A Unified Thermo-Mechanical Bounding Surface Model for Saturated Clay and Sand

A New Method for Analyzing the Thermomechanical Behavior and the Null Point Movement of Energy Piles

New Load Transfer Hyperbolic Model for Pile-Soil Interface and Negative Skin Friction on Single Piles Embedded in Soft Soils

Modeling Temperature-Dependent Behavior of Soft Clay

Analytical solutions for thermal–mechanical coupling of energy piles in double-layer soil