Abstract:Thermochemical conversion of biomass has been studied extensively over the last decades. For the design, optimization and modeling of thermochemical conversion processes, such as fixed bed pyrolysis, a sound understanding of pyrolysis is essential. However, the decomposition mechanism of most biomass types into gaseous, liquid, and solid fractions is still unknown because of the complexity of pyrolysis and differences in biomass composition.The aim of this study was to find characteristic differences in the pyrolysis behavior of three widely used biomass feedstocks to optimize the performance of industrial fixed bed pyrolysis. This aim was achieved in three steps. First, devolatilization kinetics during pyrolysis of three biomass types was investigated in a thermogravimetric analyzer (TGA). Then, a one-step multi-component pyrolysis model with three independent parallel reactions for hemicellulose, cellulose and lignin was derived to correlate the kinetics with single component decomposition and to identify their amount in the biomass sample. In a final step, the findings were tested in a fixed bed reactor at laboratory scale to prove applicability in industrial processes.Three types of biomass were chosen for this investigation: wheat straw, rape straw and spruce wood with bark. They represent biomass with a high cellulose, hemicellulose and lignin content, respectively. Since lignin is the most stable and complex of these three biomass components, its amount is assumed to be the main controlling factor in the thermochemical decomposition process.The thermogravimetric (TG) curve of spruce wood with bark was found to shift to about 20K higher temperatures compared to the TG curves of straw and rape straw. This result indicates that a higher activation energy is needed to decompose woody biomass, which contains a higher amount and a different type of lignin than straw. Three wood decomposition phases were distinguished from the negative first derivatives curves (DTG): a shoulder during hemicellulose decomposition, a peak during cellulose decomposition and a smaller rise during lignin decomposition. By comparison both herbaceous biomass types decomposed in only two phases at lower temperatures. The decomposition of the herbaceous, and woody biomass samples was completed at about 830K and 900K, respectively, leaving only a solid residue of ash. The derived pyrolysis model estimated the composition and described the devolatilization curves of each biomass with sufficient accuracy for industrial processes, although the same activation energy set, taken from the literature, was used for each biomass. In the fixed bed pyrolysis experiments similar characteristics were found to those in the TGA experiments. Herbaceous biomass with a higher cellulose and hemicellulose content decomposed faster and produced a larger fraction of gaseous products than woody biomass with a higher lignin content. According to the assessment of the product distribution, performed after each experiment, woody biomass pyrolysis led to a larger fraction of solid products than herbaceous biomass pyrolysis. We conclude that industrial fixed bed pyrolysis can be optimized for different biomass feedstocks with a specific composition of cellulose, hemicellulose and lignin.

Investigation of element migration characteristics and product properties during biomass pyrolysis: a case study of pine cones rich in nitrogen

Investigation on Kinetics of Bamboo Pyrolysis

Comparative Study on the Pyrolysis Behaviors of Pine Cone and Pretreated Pine Cone by Using TGA–FTIR and Pyrolysis-GC/MS

MECHANISM STUDY OF BIOMASS PYROLYSIS BY THERMOGRAVI-METRIC ANALYSIS COUPLED WITH INFRARED SPECTROSCOPY

A comparative investigation into the formation behaviors of char, liquids and gases during pyrolysis of pinewood and lignocellulosic components

Experiment Investigated on N Migration of Biomass Pyrolysis

Investigation on the Synergistic Effect Between Different Components in Pyrolysis of Paper-Plastic Composite Material

Nonisothermal Thermogravimetric Kinetic Investigations On Combustion Behaviors Of Concomitant Biomass From Urban Plants

Product Analysis and Thermodynamic Simulations from the Pyrolysis of Several Biomass Feedstocks

Pyrolysis behavior and product distributions of biomass six group components: Starch, cellulose, hemicellulose, lignin, protein and oil

Characteristics of hemicellulose, cellulose and lignin pyrolysis

Kinetic analysis and pyrolysis behavior of pine needles by TG-FTIR and Py-GC/MS

Advances in the Characterization Methods of Biomass Pyrolysis Products

NUMERICAL SIMULATION OF HEAT TRANSFER AND HETEROGENEOUS CHEMICAL REACTIONS IN A BIOMASS PARTICLE DURING PYROLYSIS

A New Insight into Pyrolysis Mechanism of Three Typical Actual Biomass: the Influence of Structural Differences on Pyrolysis Process

Influence of the Interaction of Components on the Pyrolysis Behavior of Biomass

Pyrolysis and Simulation of Typical Components in Wastes with Macro-Tga

The effect of the biomass components lignin, cellulose and hemicellulose on TGA and fixed bed pyrolysis

Experimental Investigation of Biomass Waste, (Rice Straw, Cotton Stalk, and Pine Sawdust), Pyrolysis Characteristics

Thermal Evolution of Gas-Liquid-solid Products and Migration Regulation of C/H/O Elements During Biomass Pyrolysis

Pyrolysis of Wood Species Based on the Compositional Analysis