Abstract:Thermochemical conversion of biomass has been studied extensively over the last decades. For the design, optimization and modeling of thermochemical conversion processes, such as fixed bed pyrolysis, a sound understanding of pyrolysis is essential. However, the decomposition mechanism of most biomass types into gaseous, liquid, and solid fractions is still unknown because of the complexity of pyrolysis and differences in biomass composition.The aim of this study was to find characteristic differences in the pyrolysis behavior of three widely used biomass feedstocks to optimize the performance of industrial fixed bed pyrolysis. This aim was achieved in three steps. First, devolatilization kinetics during pyrolysis of three biomass types was investigated in a thermogravimetric analyzer (TGA). Then, a one-step multi-component pyrolysis model with three independent parallel reactions for hemicellulose, cellulose and lignin was derived to correlate the kinetics with single component decomposition and to identify their amount in the biomass sample. In a final step, the findings were tested in a fixed bed reactor at laboratory scale to prove applicability in industrial processes.Three types of biomass were chosen for this investigation: wheat straw, rape straw and spruce wood with bark. They represent biomass with a high cellulose, hemicellulose and lignin content, respectively. Since lignin is the most stable and complex of these three biomass components, its amount is assumed to be the main controlling factor in the thermochemical decomposition process.The thermogravimetric (TG) curve of spruce wood with bark was found to shift to about 20K higher temperatures compared to the TG curves of straw and rape straw. This result indicates that a higher activation energy is needed to decompose woody biomass, which contains a higher amount and a different type of lignin than straw. Three wood decomposition phases were distinguished from the negative first derivatives curves (DTG): a shoulder during hemicellulose decomposition, a peak during cellulose decomposition and a smaller rise during lignin decomposition. By comparison both herbaceous biomass types decomposed in only two phases at lower temperatures. The decomposition of the herbaceous, and woody biomass samples was completed at about 830K and 900K, respectively, leaving only a solid residue of ash. The derived pyrolysis model estimated the composition and described the devolatilization curves of each biomass with sufficient accuracy for industrial processes, although the same activation energy set, taken from the literature, was used for each biomass. In the fixed bed pyrolysis experiments similar characteristics were found to those in the TGA experiments. Herbaceous biomass with a higher cellulose and hemicellulose content decomposed faster and produced a larger fraction of gaseous products than woody biomass with a higher lignin content. According to the assessment of the product distribution, performed after each experiment, woody biomass pyrolysis led to a larger fraction of solid products than herbaceous biomass pyrolysis. We conclude that industrial fixed bed pyrolysis can be optimized for different biomass feedstocks with a specific composition of cellulose, hemicellulose and lignin.

Characteristics of hemicellulose, cellulose and lignin pyrolysis

In-Depth Investigation of Biomass Pyrolysis Based on Three Major Components: Hemicellulose, Cellulose and Lignin

Experimental Study of Biomass Pyrolysis Based on Three Major Components: Hemicellulose, Cellulose, and Lignin

Cellulose, Xylan and Lignin Interactions During Pyrolysis of Lignocellulosic Biomass

Pyrolysis of biomass components in a TGA and a fixed-bed reactor: Thermochemical behaviors, kinetics, and product characterization

The effect of the biomass components lignin, cellulose and hemicellulose on TGA and fixed bed pyrolysis

Influence of Interactions among Three Biomass Components on the Pyrolysis Behavior

Pyrolysis kinetic analysis of the three pseudocomponents of biomass–cellulose, hemicellulose and lignin

TGA-FTIR Analysis of Biomass Samples Based on the Thermal Decomposition Behavior of Hemicellulose, Cellulose, and Lignin

Volatile production from pyrolysis of cellulose, hemicellulose and lignin

Pyrolytic Characteristics of Hemicellulose, Cellulose and Lignin under CO2 Atmosphere

Inner-particle reaction mechanism of cellulose, hemicellulose and lignin during photo-thermal pyrolysis process: Evolution characteristics of free radicals

Fast Pyrolysis Behavior of Lignocellulosic Biomass Model Compound: Releasing Properties, Kinetic Analysis of the Primary Gaseous Products and Char Structure Evolution from Cellulose

Influence of the Interaction of Components on the Pyrolysis Behavior of Biomass

Interactions of biomass components during pyrolysis: A TG-FTIR study

Pyrolysis Behavior of Cellulose, Xylan and Lignin

The interactions among the pyrolysis of biomass components based on the PY-GC/MS

Pyrolysis behavior and product distributions of biomass six group components: Starch, cellulose, hemicellulose, lignin, protein and oil

On-line analysis on fast pyrolysis of lignocellulosic biomass: thermal behavior and kinetic analysis of hemicellulose

Analytical pyrolysis studies of corn stalk and its three main components by TG-MS and Py-GC/MS

Interactions Between Cellulose and Lignin During Pyrolysis: Evolutions of Condensed-Phase Functional Groups and Gas-Phase Volatile Fraction