Abstract:During the transitional processes of load rejection in a pumped-storage station, the S-shaped characteristics of the pump-turbines can result in relatively large water-hammer and pulsating pressures. These pressures and the high runaway speed during transient processes may directly damage the penstocks and shorten the life of the turbine. In this study, different guide-vane closing schemes for reducing the maximum transient pressures, including the water-hammer and pulsating pressures, and runaway speed were investigated, and the principles for improving the closing schemes were theoretically analyzed based on the transient characteristics in the S-shaped region. First, an analytical expression for the rate of change of relative water head during the transitional processes was deduced based on a simplified mathematical model. It reveals the relationship between the slopes of the trajectory at the pump-turbine operating points (defined as trajectory slopes) and the rigid water-column pressure, which approximates the water-hammer pressure considering compressibility. Then, based on the characteristics of the rigid water-column pressure during the transient process and the effects of guide-vane closure on the trajectory slopes, the selection method for a two-phase guide-vane closing scheme was proposed. The method included the technique for choosing the coordinates of the turning point and the closing speed of the guide vane. Furthermore, the pulsating pressures of pump-turbines were discussed under different working regions and guide-vane openings (GVOs). Considering the characteristics of the pulsating pressures and the runaway speed during the transient processes, the advantage of three-phase valve-closing schemes in controlling the pulsating pressures and the runaway speed was clarified. Finally, a series of model tests were conducted on a pumped-storage station model and the measured data fully validated the correctness of our analyses in this work.

Research on ball valve and misaligned guide vane devices to improve the “S” characteristics of a pump turbine

Influence of End Wall Clearance on Guide Vane Self-Excited Vibrations at Small Openings during Pump Mode’s Starting Up Process of a Reversible Pump Turbine

A new start-up law of pump turbines with misaligned guide vane devices

Analysis of S Characteristics and Pressure Pulsations in a Pump-Turbine With Misaligned Guide Vanes

Numerical Analysis of the Effect of Misaligned Guide Vanes on Improving S-Shaped Characteristics for a Pump-Turbine

Transient Simulation of a Pump-Turbine with Misaligned Guide Vanes During Turbine Model Start-Up

Optimization of Pump Turbine Closing Operation to Minimize Water Hammer and Pulsating Pressures During Load Rejection

Guide-Vane Closing Schemes for Pump-Turbines Based on Transient Characteristics in S-shaped Region

Study on the Transient Characteristics of Pump During the Starting Process with Assisted Valve

S-shaped characteristics of pump turbine with large guide vane opening by experimental and numerical analysis

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump

Impact of guide vane opening angle on the flow stability in a pump-turbine in pump mode

Influence of hydraulic characteristics on transient behavior of ultra-high head pump turbine

Effect of valve opening on starting performance of pump as turbine

Numerical simulation and experimental research the characteristic at rated guide vane opening on pump-turbine

Numerical Study on Valve Closing Criteria during Pump-turbine Start-up on Pump Mode

Numerical Analysis of Misaligned Guide Vanes Effect Pressure Oscillations in a Prototype Pump Turbine

Numerical Investigation of Guide Vane Hydraulic Torque Characteristics of a Pump Turbine in Pump Mode

Dynamic hydraulic characteristics of a prototype ball valve during closing process analysed by 3D CFD method

Investigations into Hydraulic Instability during the Start-Up Process of a Pump-Turbine under Low-Head Conditions

Influence of Different Valve Openings on the Structural Dynamic Characteristics of a Multistage Pump