Abstract:The detailed understanding of the electronic properties of semiconducting materials requires the determination of their joint density of states (JDOS) and dielectric constant with high spatial resolution. Low electron energy loss spectroscopy (EELS) provides a continuous spectrum which represents all electronic excitations with energies ranging between zero and about 100 eV. Therefore EELS is potentially more powerful than conventional optical spectroscopy which has an intrinsic upper information limit of about 6 eV due to absorption of light from the optical components of the system or the ambient. However, when analysing EELS data, the extraction of the single scattered data needed for Kramers–Kronig calculations is subject to the deconvolution of the zero loss peak from the raw data. This procedure is particularly critical when attempting to study the near-bandgap region of materials with a bandgap below 1.5 eV. In this paper calculation of the electronic properties of some widely studied carbon materials; namely amorphous carbon (a-C), tetrahedral amorphous carbon (ta-C), C60 fullerite crystal as well as synthetic and natural diamond, are presented. Extrapolation of a fit to the absorption data at the onset of an interband transition was used to get an accurate value for the bandgap energy and to determine whether the bandgap is direct or indirect in character. Particular problems relating to the extraction of the single scattered data for these materials are also discussed. The ta-C and C60 fullerite materials are found to be direct bandgap-like semiconductors, having a bandgap of 2.63 and 1.59 eV, respectively. On the other hand, the electronic structure of a-C was unobtainable because it had such a small bandgap that most of the information is contained in the first 1.2 eV of the spectrum, which is a region removed during the zero loss peak deconvolution. The processing of the data obtained from the ta-C material revealed another benefit of using EELS: the electrons of the beam can transfer momentum and energy to the electrons of the material, thus enabling the probing of indirect interband transitions. Use of this extra feature of EELS coupled with the extremely high spatial resolution obtainable in a scanning electron microscope has indicated that tetrahedral carbon thin films might not be amorphous after all, implying the need for a fresh look at their use as electronic materials.

SYNTHESIS OF CARBON DOTS (CDS) AND DETERMINATION OF OPTICAL GAP ENERGY WITH TAUC PLOT METHOD

KARAKTERISTIK SIFAT OPTIK NANOPARTIKEL KARBON (CARBON DOTS) DENGAN METODE UV-VIS DRS (ULTRAVIOLET-VISIBLE DIFFUSE REFLECTANCE SPECTROSCOPY)

Optical Properties of Carbon Dots Synthesized by the Hydrothermal Method

Tauc Plot Software: Calculating energy gap values of organic materials based on Ultraviolet-Visible absorbance spectrum

High green-emission carbon dots and its optical properties: Microwave power effect

Synthesis and Investigation of Structural and Optical Properties of Nitrogen-doped Carbon Quantum Dots

Surface Functional Groups Effect on the Absorption Spectrum of Carbon Dots: Initial TD-DFT Study

Calculation of the Electronic Structure of Carbon Films Using Electron Energy Loss Spectroscopy

Study of the Electronic Structure of Carbon Materials Near the Bandgap Using Electron Energy Loss Spectroscopy

Optical properties of carbon dots generated in liquid by pulsed IR laser at 1064 nm

Unraveling the Fluorescence Mechanism of Carbon Dots with Sub-Single-Particle Resolution

Calculation of the Bandgap and of the Type of Interband Transitions in Tetrahedral Amorphous Carbon Using Electron Energy Loss Spectroscopy

Impact of the Concentration Ethylenediamine on Optical Properties of Carbon Dots from Jengkol Peel (Archinendron pauciflorum)

Excitation-Dependent Photoluminescence from Single-Carbon Dots

Citric Acid Derived Carbon Dots, the Challenge of Understanding the Synthesis-Structure Relationship

Full-colour Carbon Dots: from Energy-Efficient Synthesis to Concentration-Dependent Photoluminescence Properties

Surface relaxation determine the band bending and special optical properties of carbon nanodots

Measuring the refraction index of luminescent carbon nanodots forming Gaussian beam using the tracker software

Considerations about the determination of optical bandgap from diffuse reflectance spectroscopy using the tauc plot

Carbon Dots and Their Polymeric Nanocomposites: Insight into Their Synthesis, Photoluminescence Mechanisms, and Recent Trends in Sensing Applications

Investigating the Structural, Dielectric, Optical and Photocatalytic Properties of Carbon Dots and Palladium, Platinum Decorated Carbon Dots