Abstract:CO2 separation is an important environmental method mainly used in reducing CO2 emissions to mitigate anthropogenic climate change. The use of mixed-matrix membranes (MMMs) arrives as a possible answer, combining the high selectivity of inorganic membranes with high permeability of organic membranes. However, the combination of these materials is challenging due to their opposing nature, leading to poor interactions between polymeric matrix and inorganic fillers. Many additives have been tested to reduce interfacial voids, some of which showed potential in dealing with compatibility problems, but most of them lack further studies and optimization. Deep eutectic solvents (DESs) have emerged as IL substitutes since they are cheaper and environmentally friendly. Choline chloride-based deep eutectic solvents were studied as additives in polyethersulfone (PES)/SAPO-34 membranes to improve CO2 permeability and CO2/N2 and CO2/CH4 selectivity. SAPO-34 crystals of 150 nm with a high surface area and microporosity were synthesized using dry-gel methodology. The PES/SAPO-34 membranes were optimized following previous work and used in a defined composition, using 5 or 10 w/w% of DES during membrane preparation. All MMMs were characterized by their ideal gas permeability using N2 and CO2 pure gasses. Selected membranes were also tested using CH4 pure gas. The results presented that 5 w/w%, in polymer mass, of ChCl–glycerol presented the best result over the synthesized membranes. An increase of 200% in CO2 permeability maintains the CO2/N2 selectivity for the non-modified PES/SAPO-34 membrane. A CO2/CH4 selectivity of 89.7 was obtained in PES/SAPO-34/ChCl-glycerol membranes containing 5 w/w% of this DES, which is an outstanding ideal separation performance for MMMs when compared to other results in the literature. FTIR analysis reiterates the presence of glycerol in the membranes prepared. Dynamic Mechanical Thermal Analysis (DMTA) shows that the addition of 5 w/w% of DES does not impact the membrane flexibility or polymer structure. However, in concentrations higher than 10 w/w%, the inclusion of DES could lead to high membrane rigidification without impacting the overall thermal resistance. SEM analysis of DES-enhanced membranes presented asymmetric final membranes and reaffirmed the results obtained in DMTA about rigidified structures and lower zeolite–polymer interaction with higher concentrations of DES.

Improvement of CO2/CH4 separation characteristics of polyethersulfone by modifying with polydimethylsiloxane and nano-silica

Molecular‐Sieving Membrane by Partitioning the Channels in Ultrafiltration Membrane by in Situ Polymerization

Fabrication of highly selective hollow fiber membranes based on P84/PES blends for CO2/CH4 separation

Enhancing CO2/N2 and CO2/CH4 Separation Properties of PES/SAPO-34 Membranes Using Choline Chloride-Based Deep Eutectic Solvents as Additives

Innovative strategies for enhancing gas separation: Ionic liquid-coated PES membranes for improved CO 2 /N 2 selectivity and permeance

Preparation and properties of polyethersulfone hollow fiber membranes with o -xylene as an additive used in membrane contactors for CO 2 absorption

Fabrication of Polydimethysiloxane (PDMS) Dense Layer on Polyetherimide (PEI) Hollow Fiber Support for the Efficient CO2/N2 Separation Membranes

Morphology and characteristics of polyethersulfone membrane modified with polyethylene glycol hexadecyl ether and nanocarbon

Effect of incorporated hybrid MIL-53(Al) and MWCNT into PES membrane for CO2/CH4 and CO2/N2 separation

Carbon Molecular Sieve Membrane Preparation by Economical Coating and Pyrolysis of Porous Polymer Hollow Fibers

Highly permeable polyethersulfone substrates with bicontinuous structure for composite membranes in CO2/N2 separation

Separation properties and fouling resistance of polyethersulfone membrane modified by fungal chitosan

Gas permeation and selectivity of polysulfone/carbon non-woven fabric membranes with sponge and finger-like structures

Preparation of a PVA/Chitosan/Glass Fiber Composite Membrane and the Performance in CO2 Separation

Optimization of Coating Solution Viscosity of Hollow Fiber‐supported Polydimethylsiloxane Membrane for CO2/H2 Separation

Enhanced 2-D MOFs nanosheets/PES-g-PEG mixed matrix membrane for efficient CO2 separation

The Effect of Concentration on PES/NMP System on Flat Sheet Membrane Fabrication and its Performance for CO2 Gas Separation

Impacts of Multilayer Hybrid Coating on PSF Hollow Fiber Membrane for Enhanced Gas Separation

Preparation and characterization of a polyethersulfone/polyaniline nanocomposite membrane for ultrafiltration and as a substrate for a gas separation membrane

Enhanced gas separation performance for H 2 purification using MIL-68(ln)-nh 2 /PES mixed-matrix membranes

Improving gas permeation performance of PDMS by incorporating hollow polyimide nanoparticles with microporous shells and preparing defect-free composite membranes for gas separation