Improving Modeling of Swept Volume of Taper Cutter Used in Five-Axis NC Machining Simulation
Hou Zengxuan,Wang Zengqiang,Chang Gang
DOI: https://doi.org/10.3969/j.issn.1000-2758.2006.04.018
2006-01-01
Abstract:Aim.The performance and flexibility of current commercial systems in modeling swept volume of taper cutter used in five-axis NC(numerical control) machining simulation can,in our opinion,be improved.We present a new compressed voxel-based method that has,in our opinion,succeeded in implementing such improvement.In the full paper,we explain our new method in detail; in this abstract,we just mention the three topics of our explanation:(1) brief introduction to compressed voxel-based model;(2) construction of swept volume model of taper cutter based on compressed voxel;the subtopics are construction of character curves of surface of moving sphere(subtopic 2.1),construction of character curves of surface of moving cone(subtopic 2.2),and the construction and application of the compressed voxel-based swept volume modeling of taper cutter(subtopic 2.3);under subtopics 2.1 and 2.2,eqs.(1) and(2) are derived;under subtopics 2.1 and 2.2 ray casting method is used to establish and discretize the swept surface models of the sphere and taper respectively;under subtopic 2.3 the Boolean operations are used to model the swept volume of the taper cutter;again,under subtopic 2.3 solid models of the cutter and workpiece are stored in the form of three mutually perpendicular ray arrays along X,Y,Z axis respectively,resulting in a compressed voxel model;under subtopic 2.3,we explain that Boolean operation of the cutter swept volume model with workpiece is fulfilled among one-dimensional dexel arrays and workpiece at high speed;again,under subtopic 2.3 marching cube algorithm is applied to build the triangular mesh model of machined workpiece which can be observed in real time from any direction.This method has been realized in five-axis NC machining simulation system with higher performance and flexibility in operation than current commercial systems in their 3D modeling.The method is the key technology for the virtual numerical control machining.