Abstract:This paper explores the possibility to use statistical energy analysis (SEA)-based computations to synthesize sounds that can be used in a subjective evaluation of the unpleasantness of exterior noises transmitted in the car compartment through the glazing. A medium family car (C-segment car) was placed in a reverberation room. A sound source was placed outside the car. The resulting noise was measured at the driver's position for nineteen different configurations of glazing. The transmission loss (TL) of each car window was computed using an in-house software and used in a SEA-based vibroacoustic synthesis model. The nineteen corresponding configurations were simulated. A listening test experiment was conducted to compare the signals synthesized from the measurements and from the simulations. The results showed a good agreement between the unpleasantness ratings of each glazing configuration. However, in the case of tempered glasses, a slight difference in the ratings was detected. Further analysis showed that this was due to an inaccurate prediction of the TL of the glazing, around its coincidence frequency. Additional measurements proved that this could be related to an underestimation of the damping. More precisely, because the intrinsic damping of a tempered glass is very low, the additional damping brought by the window seals must be taken into account. Further measurements were made to estimate the TL of a tempered glass mounted on a gasket. The use of these new values in the SEA calculation allowed for the correction of these difference in subjective ratings. The SEA computations can thus be used in the acoustic design process of cars.

Experimental Study of an Active Window for Silent and Comfortable Vehicle Cabins

Experimental Research of Noise Control in the Fighter Cockpit Using Microperforated Panel Absorber Structure

Study on active noise control inside automobile cabin

Active vibration control for window rattling caused by infrasound: Field experiment for one pair of sliding glass doors installed on the test building

Active Noise Attenuation in Ventilation Windows.

Numerical simulation of the sound field inside a natural ventilation window

Numerical and experimental-based framework for vibro-acoustic coupling investigation on a vehicle door in the slamming event

Sound insulation design of vehicle side window glass based on acoustic black holes

Causal feedforward control of a stochastically excited fuselage structure with active sidewall panel

Comparison of hydrodynamic and acoustic pressure on automotive front side window

Influence of Glazing on Sound Quality in the Car: Validation of Auralizations Obtained from SEA Calculations

Active Noise Control Using a Body-Mounted Vibration Actuator to Enhance the Interior Sound of Vehicle

Integrated Solutions for Noise and Vibration Control in Vehicles

Design of full vehicle PBNR based on side windows with embedded acoustic black holes

A feasibility study on active sound reduction across an acoustic plenum window by cancelling source clusters on internal periphery of the window cavity

Feasibility study on the active structural attenuation of multiple band vibrations from two dimensional continuous structures in automotive vehicles

Noise Reduction in Helicopter Cabins Using Microperforated Panel Composite Sound Absorption Structures

Case study: Reference optimization for active control of air conditioning noise at defrost mode in vehicles

A Feedback Active Control Approach to Road Noise Based on a Single Microphone Sensor to Improve Automotive Cabin Sound Comfort

Combined Feedforward–Feedback Active Control of Road Noise Inside a Vehicle Cabin

Research on the Active Noise Control Technology for the Reduction of the Air Conditioner Noise in a Vehicle Cabin