Abstract:Systematic errors induced by distortions in the pump pulse of conventional Brillouin distributed fiber sensors are thoroughly investigated. Experimental results, supported by a theoretical analysis, demonstrate that the two probe sidebands in standard Brillouin optical time-domain analyzers provide a non-zero net gain on the pump pulse, inducing severe distortions of the pump when scanning the pump-probe frequency offset, especially at high probe power levels. Compared to the impact of non-local effects reported in the state-of-the-art, measurements here indicate that for probe powers in the mW range (below the onset of amplified spontaneous Brillouin scattering), the obtained gain and loss spectra show two strong side-lobes that lead to significant strain/temperature errors. This phenomenon is not related to the well-known spectral hole burning resulting from pump depletion, but it is strictly related to the temporal and spectral distortions that the pump pulse experiences when scanning the Brillouin gain/loss spectrum. As a solution to this problem, a novel scanning scheme for Brillouin sensing is proposed. The method relies on a fixed frequency separation between the two probe sidebands, so that a flat zero net gain is achieved on the pump pulse when scanning the pump-probe frequency offset. The proposed technique is experimentally validated, demonstrating its ability to completely cancel out non-local effects up to a probe power ultimately limited by the onset of amplified spontaneous Brillouin scattering. The method allows for one order of magnitude improvement in the figure-of-merit of optimized long-range Brillouin distributed fiber sensors, enabling measurements along a 100 km-long sensing fiber with 2 m spatial resolution and with no need of added features for performance enhancement.

BOTDA-Based Technique for Measuring Maximum Loss and Crosstalk at Splice Point in Few-Mode Fibers

Low-Loss All-Fiber Mode Multiplexers for Weakly-Coupled 4-Mode Fiber

Performance of long-range loss-mechanism Brillouin optical-fiber time-domain analysis

Performance Enhancement in a Few-Mode Rayleigh-Brillouin Optical Time Domain Analysis System Using Pulse Coding and LMD Algorithm

Dual-Parameter Active Fibre Sensor Based On Modal Interference In Few-Mode Fibres

Influence of Pump Light on LP01 and LP11 Modes in Few-Mode Fiber Brillouin Optical Time Domain Reflectometry

Investigation on Beam Expansion Method for Weakly-Coupled FMF Connections

Simulation Analysis on the Simultaneous Deployment of Brillouin Gain and Loss in Coded Brillouin Optical Time Domain Analysis (BOTDA) Fiber Sensor

All-Optical Wavelength Conversion for Mode-Division Multiplexing Signals Using Four-Wave Mixing in A Dual-Mode Fiber

Low-modal-crosstalk Doped-Fiber Amplifiers in Few-Mode Fiber-Based Systems

Angle-Spliced SMF to Hollow Core Fiber Connection with Optimized Back-Reflection and Insertion Loss

Low Loss Splicing Experiment of High Nonlinearity Photonic Crystal Fiber and Single Mode Fiber

Analysis and Measurement of Intra-LP-Mode Dispersion for Weakly-Coupled FMF

Fabrication and Characterization of an Optimized Low-Loss Two-Mode Fiber for Optoacoustic Sensing

Optical Performance Monitoring for Intra-LP-Mode Dispersion in Weakly-Coupled Mode-Division Multiplexed Systems

Novel scanning method for distortion-free BOTDA measurements

Statistical Analysis of Modal Dispersion in Field-Installed Coupled-Core Fiber Link

A 6-LP-mode ultralow-modal-crosstalk double-ring-core FMF for weakly-coupled MDM transmission

Differentiated Focal Plane Assisted Multi-core Fiber Fusion Splice Loss Evaluation

Stabilizing Brillouin fiber laser for applications in distributed BOTDA sensing

Single-Mode Input Fiber Combined with Multimode Sensing Fiber Used in Brillouin Optical Time-Domain Reflectometry