Acid fracturing stimulation

Frank F. Chang
DOI: https://doi.org/10.1016/b978-0-12-822721-3.00002-2
2022-01-01
Abstract:Low permeability oil and gas reservoirs often need to be hydraulically fractured to enhance their productivity. To keep the induced fracture open for the production of hydrocarbons, the fracturing step is followed by a propping step. In carbonate reservoirs, typically a crosslinked polymer fluid is pumped downhole at a high rate and pressure to crack the rock—fracturing; an acid is then injected immediately behind the crosslinked polymeric fluid to unevenly dissolve/etch the fracture walls, leaving channels once the fracture closes. These are the basic steps of an acid fracturing process. If multiple fractures are intended, diverting agents can be pumped to temporarily halt the growth of the existing fractures to allow new fractures to be generated. This chapter discusses the physical and chemical fundamentals of the acid fracturing process, the chemical products used, the engineering practices, the evaluation techniques, field treatment examples, and finally future development challenges.
What problem does this paper attempt to address?