Abstract:Abstract We combine steady-state measurements of relative permeability with pore-scale imaging to estimate local capillary pressure. High-resolution three-dimensional X-ray tomography enables the pore structure and fluid distribution to be quantified at reservoir temperatures and pressures with a resolution of a few microns. Two phases are injected through small cylindrical samples at a series of fractional flows until the pressure differential across the core is constant. Then high-quality images are acquired from which saturation is calculated, using differential imaging to quantify the phase distributions in micro-porosity which cannot be explicitly resolved. The relative permeability is obtained from the pressure drop and fractional flow, as in conventional measurements. The curvature of the fluid/fluid interfaces in the larger pore spaces is found, then from the Young-Laplace equation, the capillary pressure is calculated. In addition, the sequence of images of fluid distribution captures the displacement process. Observed gradients in capillary pressure – the capillary end effect – can be accounted for analytically in the calculation of relative permeability. We illustrate our approach with three examples of increasing complexity. First, we compare the measured relative permeability and capillary pressure for Bentheimer sandstone, both for a clean sample and a mixed-wet core that had been aged in reservoir crude oil after centrifugation. We characterize the distribution of contact angles to demonstrate that the mixed-wet sample has a wide range of angle centred, approximately, on 90°. We then study a water-wet micro-porous carbonate to illustrate the impact of sub-resolution porosity on the flow behaviour: here oil, as the non-wetting phase, is present in both the macro-pores and micro-porosity. Finally, we present results for a mixed-wet reservoir carbonate. We show that the oil/water interfaces in the mixed-wet samples are saddle-shaped with two opposite, but almost equal, curvatures in orthogonal directions. The mean curvature, which determines the capillary pressure, is low, but the shape of the interfaces ensures, topologically, well-connected phases, which helps to explain the favourable oil recovery obtained in these cases. We suggest that the combination of imaging and flow experiments – which we call iSCAL – represents a compelling development in special core analysis. This methodology provides the data traditionally acquired in SCAL studies, but with insight into displacement processes, rigorous quality control, and flexibility over sample selection, while generating detailed datasets for the calibration and validation of numerical pore-scale flow models.

Pore Size Distribution and Soil Water Suction Curve from Micro-tomography Measurements and Real 3-D Digital Microstructure of a Compacted Granular Media by Using Direct Numerical Simulation Technique

Influence Of Pore Distribution Characteristics On Relative Hydraulic Conductivity In Soil Covers - A Pore-Scale Numerical Investigation

Quantification and Characterization of Microporosity by Image Processing, Geometric Measurement and Statistical Methods: Application on Sem Images of Clay Materials

Visualization and Quantification of Capillary Drainage in the Pore Space of Laminated Sandstone by A Porous Plate Method Using Differential Imaging X-Ray Microtomography

Investigation of porosity variation on water retention behaviour of unsaturated granular media by using pore scale Micro-CT and lattice Boltzmann method

iSCAL for Complete Rock Characterization: Using Pore-Scale Imaging to Determine Relative Permeability and Capillary Pressure

Construction of Soil–water Characteristic Curve of Granular Materials with Toroidal Model and Artificially Generated Packings

Three-dimensional pore structure characteristics of granite residual soil and their relationship with hydraulic properties under different particle gradation by X-ray computed tomography

Effects of particle gradation and geometry on the pore characteristics and water retention curves of granular soils: a combined DEM and PNM investigation

Network model investigation of interfacial area, capillary pressure and saturation relationships in granular porous media

Assessment of X-ray Computed Tomography to characterize filtering media from Vertical Flow Treatment Wetlands at the pore scale

Characterizing Soil Pore Structure Using Nitrogen Adsorption, Mercury Intrusion Porosimetry, and Synchrotron-Radiation-based X-ray Computed Microtomography Techniques

Numerical Simulation and Microscopic Stress Mechanism for the Microscopic Pore Deformation during Soil Compression

A graph-based approach for modeling the soil–water retention curve of granular soils across the entire suction range

Laboratory Study on Entire Range Suction Measurement and Microstructure Change of Granite Residual Soil

On the capillary stress tensor in wet granular materials

Effects of the Pore Morphology on Multiphase Fluid Displacement in Porous Media-A High-Resolution Modeling Investigation

A micro-investigation of unsaturated sand in mini-triaxial compression based on micro-CT image analysis

Modeling soil water retention curves by pore fractal dimension based on microstructure image

Review of test methods for the micro-pore characteristics of soils

Quantification of the pore size distribution of soils: Assessment of existing software using tomographic and synthetic 3D images