Abstract:Pore structure is the index reflecting the nature of the physical and mechanical properties of the soil. The resolution scale of the traditional medical CT is not high enough to identify the single grain or pore characterizing the meso-structure of geo-materials. An industrial micro-CT, with a high spatial resolution of 14 μm, is used to scan a Nanjing silty sand specimen fabricated by pluviation. The binary digital image sequence is acquired after preprocessing the CT initial images, and three-dimensional reconstruction is implemented. Arbitrary representative elementary volume (REV) is extracted, and three-dimensional binary matrix is used for the characterization of the REV and for the quantitative calculation. By analyzing the tomographic images, the volume porosity of the whole specimen is calculated, with an error of only 3.93% compared with the experimental porosity. The apparent porosity along the specimen fluctuates between 20.97 and 46.77%. Four typical sections, one horizontal, one tilting with an angle of 60 degrees to the horizon and two orthogonal vertical sections, are extracted from the REV at the bottom of the specimen. Statistical analysis of the preferred orientation is performed, and the results show that the minimum orientation angle occurs at the horizontal section, and one of the two orthogonal vertical sections exhibits the maximum orientation angle and the other exhibits the maximum anisotropic ratio, and the oblique section exhibits approximate isotropy, namely no obvious preferred orientation. The pore network model is used for spatial pore diameter analysis of three extracted REVs, and the results indicate that the maximum pore diameter distributes from 629 to 696 μm, and the minimum pore diameter does from 54 to 77 μm, and the average pore diameter does from 166 to 185 μm, and the pore diameter concentrates from 100 to 200 μm. The proposed method is capable of nondestructive quantitative analysis of pore structure variation of the spatial soil under any effect induced by heat, water or mechanics.

Investigation of porosity variation on water retention behaviour of unsaturated granular media by using pore scale Micro-CT and lattice Boltzmann method

Multiphase lattice Boltzmann modeling of cyclic water retention behavior in unsaturated sand based on X-ray Computed Tomography

Investigation of strain-sensitive properties of porous media through micro-CT imaging and numerical modelling

Micromechanical Investigation of Suffusion and Its Consequence in Gap-Graded Granular Soil at the Opening of Underground Structures Using the Coupled CFD-DEM Method

Investigating the effect of porosity on the soil water retention curve using the multiphase Lattice Boltzmann Method

Effects of particle gradation and geometry on the pore characteristics and water retention curves of granular soils: a combined DEM and PNM investigation

Simulating Two-Phase Seepage in Undisturbed Soil Based on Lattice Boltzmann Method and X-ray Computed Tomography Images

A micro-investigation of unsaturated sand in mini-triaxial compression based on micro-CT image analysis

Reproducing Micro X-ray Computed Tomography (microxct) Observations of Air–water Distribution in Porous Media Using Revised Pore-Morphology Method

Numerical Study of Water-Air Distribution in Unsaturated Soil by Using Lattice Boltzmann Method.

Pore-scale Study of Drainage Processes in Porous Media with Various Structural Heterogeneity

Three-dimensional pore structure characteristics of granite residual soil and their relationship with hydraulic properties under different particle gradation by X-ray computed tomography

Pore Size Distribution and Soil Water Suction Curve from Micro-tomography Measurements and Real 3-D Digital Microstructure of a Compacted Granular Media by Using Direct Numerical Simulation Technique

A microstructural investigation on hydraulic conductivity of soft clay

Experimental and modeling study of water-retention behavior of fine-grained soils with dual-porosity structures

Laboratory Study on Entire Range Suction Measurement and Microstructure Change of Granite Residual Soil

Fine characterization of spatial pore structure of Nanjing silty sand using micro-CT

Pore Network Modeling of Fibrous Porous Media of Uniform and Gradient Porosity

Simulation of near‐saturated flow in soil macropores with the lattice Boltzmann method

Pore Structure Analysis Via X-Ray Μct: Enhancing Soil Macroaggregate Models for Water Permeability and Carbon Sequestration

In Situ Characterisation Of The Depth And Mass Of Water Intrusion In Unsaturated Cement Pastes Via X-Ray Computed Tomography