Abstract:Soft magnetic materials with high magnetic susceptibility in response to the influence of alternating magnetic fields, generate an inductive electric voltage in the receiving coil, the spectrum of which contains higher harmonics. This is due to the nonlinear dependence of magnetization on the magnetic field, and the amplitudes of higher harmonics make a significant contribution to the overall signal if an external field leads to magnetic saturation. Magnetic susceptibility and saturation field are largely determined by magnetoelastic interactions in amorphous ferromagnets, respectively, the amplitudes of higher harmonics should depend on external mechanical stresses. In this work, we study the processes of magnetization reversal in amorphous microwires of two compositions: Co 71 Fe 5 B 11 Si 10 Cr 3 and Co 66.6 Fe 4.28 B 11.51 Si 14.48 Ni 1.44 Mo 1.69 under the action of external tensile stresses. For the first composition, mechanical stresses exceeding a certain limit (higher than 350 MPa) lead to the transformation of the magnetic hysteresis from a bistable type to an inclined one. In this case, a sharp change of the harmonic spectrum is observed. In microwires of the second composition with an initially inclined loop, external stresses cause a monotonous increase in the slope of the hysteresis loop (a decrease in susceptibility). In this case, the amplitudes of higher harmonics change significantly at low stresses, lower than 100 MPa. The results were obtained by magnetization reversal of microwire samples using a system of flat coils, which demonstrates the potential of using these materials as wireless sensors of mechanical stresses with remote reading.

Stress-Driven Magnetic Barkhausen Noise Generation in FeCo Magnetostrictive Alloy

Modelling Self-Sensing of A Magnetostrictive Actuator Based on A Terfenol-D Rod

Effect of stress on the magnetic Barkhausen noise energy cycles: A route for stress evaluation in ferromagnetic materials

Ferromagnetic Composite with Stress-Insensitive Magnetic Permeability: Compensation of Stress-Induced Anisotropies

Magnetic Barkhausen noise analysis of stress in steel

Tension-induced magnetic Barkhausen noise morphology transition caused by pre-introduced strain

In-Situ Magnetic Barkhausen Noise Measurements to Identify Elastic-Plastic Deformation and Failure in Different Steels

Stress measurement based on magnetic Barkhausen noise for thin films

Exploring Stress-Dependent Impedance Behavior Via Magnetization Dynamics in Amorphous Magnetic Fibers in High Frequency: Experimental and Modeling

Stress tunable microwave absorption of ferromagnetic microwires for sensing applications

Magnetic Field and Mechanical Stress Tunable Microwave Properties of Composites Containing Fe-based Microwires

On the Combined Effect of Elastic and Plastic Strain on Magnetic Barkhausen Noise Signals

Barkhausen Noise Application in the Detection of Stress and Fatigue Damage

Stress-Dependent Magnetization Processes in Cobalt-Based Amorphous Microwires

Field/stress Tunable Behaviour of Composites Containing the Combined Current-Modulation Annealed Ferromagnetic Microwires

Barkhausen noise in soft amorphous magnetic materials under applied stress

Highly Sensitive Magneto-Mechano-Electric Magnetic Field Sensor Based on Torque Effect

Method of measuring the stress of ferromagnetic materials based on EMAT and magnetic Barkhausen noise characteristic parameters

Evolution of the Magnetic Anisotropy and Magnetostriction in Co-based Amorphous Alloys Microwires Due to Current Annealing and Stress -Sensory Applications

Magnetic Barkhausen Noise and Magneto Acoustic Emission in Stainless Steel Plates

Stress measurement using magnetic Barkhausen noise and metal magnetic memory testing