Abstract:Bacteria zeta potential, ζ, is one of the key parameters for the deposition of bacteria on an electrode, also called electrophoretic deposition (EPD) and depends on the strain, suspension composition and pH. Measuring directly with a zetasizer is challenging due to the non-spherical shape of bacteria and the need for a lower conductivity medium which could affect the value of ζ. Electrokinetic measurements are usually performed with microchannels in PDMS [1] or in PMMA [2], both of which require expensive tools for the fabrication of either the mold or the microchannel itself. Reducing the cost and time needed to perform such measurements would enable the broader use of this technique. We anticipate solving this challenge with commercially available microfluidic chips as will be outlined in this study. Under an electric field E in a microchannel, the electrokinetic velocity of particles in a fluid is linked to two phenomena: electrophoresis (EP) due to the zeta potential of the particle and electroosmosis (EO) due to the zeta potential of the channel wall. PMMA microchannels (Microfluidic ChipShop) with 200 μl reservoirs together with a voltage sequencer (Labsmith) controlled with LabVIEW were used to characterize the velocity of 1 μm and 2 μm polystyrene beads with different surface functionalizations (nonfunctionalized polystryrene (PS), Sulfate-modified (SU-modified), Carboxylate-modified (CO-modified) and Amine-modified (AM-modified) from Invitrogen and Magsphere suspended in 10 mM HEPES (pH 7) by applying different voltages between the inlet and outlet platinum electrodes for 90 s. Recorded time-lapse fluorescent image sequences were analyzed with ImageJ and TrackMate. Electrokinetic velocities obtained by Particle Tracking Velocimetry (PTV) at different voltages were fitted with a linear fit with a high coefficient of determination allowing the extraction of the different particle zeta potentials, which are in good agreement with the control measurements performed with a Zetasizer Ultra (Malvern Panalytical) [3]. Further, this methodology was used to characterize a prevalent strain of E. coli, yielding values in agreement with the literature. The use of commercially available microfluidic chips in electrokinetic characterization could alleviate the need for microfabrication and allow the wider adoption of this characterization method. These measurements are ultimately critical to better understand the role of the zeta potential in EPD of microbes for an array of applications. [1] S. Antunez-Vela, et al., Anal Chem , 2020 [2] Q. Wang et al., Science Advances , 2019 [3] J. Cottet, et al . In preparation

Short communication: A simple and accurate method of measuring the zeta‐potential of microfluidic channels

Leveraging Commercial Microfluidic Chips for Zeta Potential Characterization

A New Online Monitoring Method for Water-in-Oil Droplet Based Microfluidic Devices

A New Contactless Bubble/Slug Velocity Measurement Method of Gas–Liquid Two-Phase Flow in Small Channels

Evaluation of polydimethylsiloxane (PDMS) surface modification approaches for microfluidic applications

Development and Validation of Optical Methods for Zeta Potential Determination of Silica and Polystyrene Particles in Aqueous Suspensions

A Streaming-Potential-based Microfluidic Measurement of Surface Charge at Immiscible Liquid-Liquid Interface

Electrokinetics In Micro-Channeled Cantilevers: Extending The Toolbox For Reversible Colloidal Probes And Afm-Based Nanofluidics

Experimental methods in chemical engineering: Zeta potential

Experimental Characterization of Electrical Current Leakage in Poly(dimethylsiloxane) Microfluidic Devices

Improved Current-Monitoring Method for Low Electroosmotic Flow Measurement in Modified Microchip

The micro-volume liquid focusing effect in Janus membrane and its biosensing application

Determination Of Zeta-Potential By Measuring Electroosmotic Flux In An Alternating Electric Field And Its Applications In The Study Of Membrane Fouling

A simple method for the evaluation of microfluidic architecture using flow quantitation via a multiplexed fluidic resistance measurement

On-chip Microfluidic Generation of Monodisperse Bubbles for Liquid Interfacial Tension Measurement.

A new method for estimating zeta potential of carboxylic acids’ functionalised particles

Studying kinetics of a surface reaction using elastocapillary effect

Surface and zeta potentials of charged permeable nanocoatings

Method for Flow Measurement in Microfluidic Channels Based on Electrical Impedance Spectroscopy

Microfluidic In Situ Measurement of Poisson's Ratio of Hydrogels

A simple method for the assessment of electrophoretic mobility in porous media