Abstract:The conjugated straight-line internal gear pair, including a pinion with straight-line profile and an internal gear with profile conjugated to the pinion profile, is the key components to the conjugated straight-line internal gear pumps. Truninger [Truninger gear pump. Patent 3491698, USA, 1970] pointed that this kind of gear pairs leads to a very small trapped volume, which is 10 times smaller than that of the conventional involute internal gear pumps. Therefore, it can yield significant reduction in noise levels of the pumps. However, to the authors' knowledge, there is no research on the design of these gear pairs until now. First, our study describes the straight-line profile of the pinion mathematically with definitions of some geometric parameters. Second, according to the theory of gearing, the mathematical models of the rack-cutter and the conjugated internal gear are derived. Then, the condition to avoid overcutting is obtained for the generation of the pinion by a rack-cutter. Finally, the condition to avoid interference in the internal gear pair is derived as a non-linear equation system and an algorithm is developed to find a numerical solution. Two examples are presented to demonstrate how to determine tooth numbers of the internal gears for avoiding interference. It is hoped that the study in this article should be helpful to the designers of the conjugated straight-line internal gear pairs. Moreover, it could provide a prepared knowledge for the researchers to investigate the performances of the fluid power gear machines, pumps, and motors, with the conjugated straight-line internal gear pumps.

Application of the geometry of conjugate curves to the design of internal-meshing rotary compressors

Essential Geometric Theory of Internal-meshing Rotary Compressor

Geometric Relationship of New Type of Internal Meshing Rotary Compressor

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

Design of the conjugated straight-line internal gear pairs for fluid power gear machines

Contact Force of Internal-Meshing Rotary Compressor

Continuity Condition of Profiles for Internal-Meshing Cycloid Rotary Compressor

Design and analysis of conical rotary compressor

Geometric Theory for a Translational Rotary Compressor

Calculation and Analysis on Volume of Working Chambers for Internal-meshing Compressor

Modification of Profile for Internal-Meshing Cycloid Rotary Compressor

Geometric model and pressurization analysis on a novel sliding vane compressor with an asymmetrical cylinder profile

Meshing Pair Geometry of the Intersecting-Axis Internally Geared Screw Compressor

Optimal Structural Design of Swing Double- vane Rotary Compressor

Position of Support Force on Cylinder in Internal-Meshing Cycloid Rotary Compressor

Design and Internal-flow Field Analysis of New Two-stage Centrifugal Compressor

Contact Force Between Gears for a New Type of Internal-Meshing Gear Compressor

Geometric Design Investigation Of Single Screw Compressor Rotor Grooves Produced By Cylindrical Milling

Geometric Model of Scroll Compressor Based on Symmetric Arc Shaped Curves with Equal Beta Angle

Geometry Scaling Technique for Aerodynamic Redesign of Multistage Transonic Compressor

Study on Rotor Profile Design of Screw Compressors Based Upon Meshing Line Method