Effect of Flash Flood and Weather Changes on Unconfined Compressive Strength of Cement- and Fly Ash-Stabilized Black Cotton Soil Used as Road Materials

B. A. Chethan,A. U. Ravi Shankar

DOI: https://doi.org/10.1007/s42947-021-00125-y

2021-11-15

International Journal of Pavement Research and Technology

Abstract:Stabilized soil naturally undergoes variation in moisture content and temperature during seasonal weather changes. In this investigation, the influence of these weather changes on unconfined compressive strength (UCS) of black cotton (BC) soil stabilized with ordinary Portland cement (43 grade) and class F fly ash was studied. Cement dosage was varied from 3 to 10%, along with different combined dosages of (cement + fly ash) (where fly ash < 32%) for stabilizing various mixes. The UCS specimens were cured for 0 (immediately after preparation) 3, 7, 28, 60, and 90 days in a desiccator and subsequently submerged for 24 h in water to ensure saturation. The flash flood effect was evaluated in terms of strength reduction by correlating UCS of saturated specimens (UCSs) with UCS of desiccator-cured specimens. The stabilized materials’ resistance to wetting–drying (WD), freezing–thawing (FT) durability tests and subsequent UCS retained over time were determined. The UCS values increased substantially at higher cement and fly ash contents and with the curing period, whereas a notable reduction in UCSs values was observed for saturated samples. However, the samples with high cement and fly ash contents exhibited low moisture susceptibility with lesser strength reduction. The UCS and UCSs values are linearly correlated with R2 values > 0.9. All the specimens were intact with improved volume stability at higher cement and fly ash dosages during saturation and drying. Mixes with high cement and fly ash dosages shown improved resistance to WD cycles, whereas at a low dosage, most of the mixes failed during the second wetting cycle due to a drastic absorption of water after the first drying cycle. All FT specimens were intact with considerable strength retained after 12 cycles exhibiting a minimal mass loss. The formation of hydration products has justified the strength gain as observed from scanning electron microscope (SEM) images, energy dispersive X-Ray analysis (EDAX), and X-ray diffraction (XRD) plots.