Abstract:Probes that penetrate soil are used in fields such as geotechnical engineering, agriculture, and ecology to classify soils and characterize their properties in situ. Conventional tools like the Cone Penetration Test (CPT) often face challenges due to the lack of reaction force needed to penetrate stiff or dense soil layers, necessitating larger drill rigs. This paper investigates more efficient means of penetrating soil taking inspiration from a plant-root motion known as circumnutation. Experimental penetration tests on sands are performed with circumnutation-inspired (CI) probes that advance at a constant vertical velocity (v) while simultaneously rotating at a constant angular velocity (ω). These probes have tips have a given bent angle (α) and bent length (L 1 ). The variation of the mobilized vertical force (F z ), torque (T z ), and the mechanical work components with the relative tangential to vertical velocity (\omega R/v) is investigated along with the effects of probe geometry, v, and soil relative density (D R ). The results show that the soil penetration resistance does not vary with v, but it increases as \alpha, L 1 , and D R are increased. F z decays exponentially with increasing ωR/v, T z initially increases and then plateaus, while total work (W T ) shows little magnitude changes initially but later increases monotonically. The mechanisms governing these trends are identified as changes in the probe projected areas and mobilized normal stresses due to differences in probe geometry and the effects of ωR/v on the resultant force direction and soil disturbance. The results show that CI penetration within a specific range of ωR/v leads to small increases in W T (i.e., ≦25%), yet mobilizes F z magnitudes that are 50 to 80% lower than that mobilized during non-rotational penetration. This indicates that CI penetration can be adopted for in situ characterization or sensor placement with smaller vertical forces, allowing for use of lighter rigs.

Effect of Cone Diameter on Determination of Penetration Resistance Using a FCV

Static and Dynamic Cone Penetrometer Tests for Babolsar Sand Parameters via Physical Modeling

Assessing the Bearing Capacity of Backfills by Stress Wave Velocity and Cone Penetration Resistance

Interpretation of Piezocone Penetration Tests in Centrifuge

A numerical investigation on the effect of rotation on the Cone Penetration Test

Application of the Dynamic Cone Penetrometer (DCP) for determination of the engineering parameters of sandy soils

Discrete element model (DEM) simulations of cone penetration test (CPT) measurements and soil classification

A new shared miniature cone penetrometer for centrifuge testing

Numerical simulation of cone penetration test by using CFD–DEM coupled analysis

Assess the Effects of Loading Rate and Interface Roughness on T-bar Penetration Resistance

Field Studies of Dynamic Compaction on Marine Deposits

Experimental and Numerical Study of Rate Effect in Cone Penetration Tests

Interpretation of centrifuge CPT data in normally consolidated silica and carbonate sands

Effect of Large Deformation Analysis for Site Investigation Tool - CPT in Layered Soils

Laboratory Testing of Kinetic Sand as a Reference Material for Physical Modelling of Cone Penetration Test with the Possibility of Artificial Neural Network Application

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

Discrete element modelling of rotary CPT and its applications

Comparison of California Bearing Ratio (CBR) Value Based on Cone Penetration Test (CPT) and Dynamic Cone Penetrometer (DCP)

On use of dynamic probing in sandy soils

Experimental investigation of circumnutation-inspired penetration in sand

A cone penetration test database for multiple thin-layer correction procedure development