Abstract:Multi-laser powder bed fusion (PBF-MLB) is an advanced additive manufacturing (AM) technology, which can effectively improve the forming size and efficiency of components by increasing the number of lasers. However, the high residual stress generated by the repeated melting and solidification of the material in the overlap region under the action of multi-laser adversely affects formability during the PBF-MLB process. In this respect, this manuscript presents a stress control method based on the spatial and temporal differences in scanning strategies between dual-laser in PBF-MLB. A three-dimensional finite element model based on the sequentially coupled thermal-structural method was established to forecast the influence of these scanning strategies on the thermal history and residual stress distribution in both overlap and isolated regions. Meanwhile, the effective absorptivity of Ti-6Al-4V alloy powder was measured using a self-made calorimeter. The laser absorptivity of Ti-6Al-4V alloy powder was found to be 42.8% when P=170W and V=600mm/s, which was used in the simulation. The simulation results show that with the use of spatial difference scanning strategies (SDSC), the residual stress in the overlap region was greatly reduced by avoiding multiple synchronous remelting of the dual-laser. Meanwhile, after implementing temporal difference scanning strategies (TDSC) and spatial-temporal difference scanning strategies (S-TDSC), a lower temperature gradient was achieved compared to dual-laser synchronous scanning because only a single laser performs the processing. Therefore, the residual stress in the overlap region was significantly alleviated. Furthermore, the residual stress in the overlap region was lower with S-TDSC than with TDSC due to the more continuous thermal cycle created by the laser. In the inward symmetric scanning mode, the residual stress in the overlap region was reduced by 9.8% through using the SDSC compared to the base scanning strategy.

Study on the Effect of Scanning Strategy on Residual Stress in Laser Additive Manufacturing with the Laser Ultrasound Technique

Role of Scanning Strategy on Residual Stress Distribution in Ti-6Al-4V Alloy Prepared by Selective Laser Melting

The Effect of Scanning Strategy on the Thermal Behavior and Residual Stress Distribution of Damping Alloys during Selective Laser Melting

The Effect of a Scanning Strategy on the Residual Stress of 316L Steel Parts Fabricated by Selective Laser Melting (SLM)

Numerical Analysis of the Effect of the Spatial and Temporal Scanning Strategies on the Residual Stress in the Multi-Laser Powder Bed Fusion of Ti-6Al-4V

Ultrasonic Measurement of Stress in SLM 316L Stainless Steel Forming Parts Manufactured Using Different Scanning Strategies

Effect of Overlap Rate and Pattern on Residual Stress in Selective Laser Melting

The effect of rescanning strategy on residual stress and deformation of laser-based powder bed fusion of 316L stainless steel thin-walled parts

Effect of in-situ ultrasonic impact treatment on residual stress of laser deposition layer

Effect Of Scanning Routes On The Stress And Deformation Of Overhang Structures Fabricated By Slm

Geometrical effects on residual stress in selective laser melting

X-ray diffraction measurements and computational prediction of residual stress mitigation scanning strategies in powder bed fusion additive manufacturing

Effect Of Scanning Path On Thermo-Mechanical Field Of Laser Solid Forming Tc4 Part

Comparison of two scan strategies applied to the selective laser melting

Scanning strategy in selective laser melting (SLM): a review

Effect of Path Strategy on Residual Stress and Distortion in Laser and Cold Metal Transfer Hybrid Additive Manufacturing

Planning of Area-Partition Scanning Path and Its Effect on Residual Stress of SLM Molding Parts

Residual stresses and deformations of laser additive manufactured metal parts: a review

Residual stress reduction in Ti-6Al-4V parts fabricated by laser-foil-printing process

Impact of scan strategy on principal stresses in laser powder bed fusion

Novel Strategy for Reducing Residual Stress in Titanium Alloy Parts Obtained via Additive Manufacturing