A Common Grounded Non-Isolated ASISC High Gain DC-DC Converter with Oscillation Mitigation Across Switches
Avneet Kumar,Sahendara Kumar,Xuewei Pan,Motiur Reza Mohammed,Danyang Bao
DOI: https://doi.org/10.1109/jestie.2024.3485174
2024-01-01
IEEE Journal of Emerging and Selected Topics in Industrial Electronics
Abstract:In fuel cell vehicle (FCV), dc-dc converter is an integral part. Active switched inductor/capacitor (ASISC) based topology is an attractive solution for FCV because it has low switch voltage stress, current stress, and simple design and control. However, the voltage stress in the switches of an active switched inductor (ASI) network is very sensitive to the switch's capacitance and inductance values. The inductors and drain-source capacitors of the switch constitute a resonance circuit due to the parameters' inconsistency of the ASL network. This introduces voltage oscillation across switches and eventually, the switch voltage stress shoots up. The oscillating voltage increases the power loss in the converter. In this paper, a new hybrid structure of an active switched inductor/switched capacitor (ASISC) DC-DC converter is derived. The proposed converter provides a high voltage conversion ratio, mitigates voltage oscillation across switches, resulting in reduced voltage stress across switch, and provides common ground between source and load ends. This paper gives the converter key waveform, operating principle, detailed steady-state analysis, and design equations. The voltage conversion ratio, voltage stress, and current stress are derived and compared with existing ASISC converters. Finally, the prototype is developed and the working is demonstrated with 300 W for voltage conversion from 35V to 300V.