Abstract:In the process of promoting the commercialization of proton exchange membrane fuel cells, the long-term durability of the fuel cell has become a key consideration. While existing durability tests are critical for assessing cell performance, they are often time-consuming and do not quickly reflect the impact of actual operating conditions on the cell. In this study, improved testing protocols were utilized to solve this problem, which is designed to shorten the testing cycle and evaluate the degradation of the cell performance under real operating conditions more efficiently. Accelerated durability analysis for evaluating the MEA lifetime and performance decay process was carried out through two testing protocols—open circuit voltage (OCV)-based accelerated durability testing (ADT) and relative humidity (RH) cycling-based ADT. OCV-based ADT revealed that degradation owes to a combined mechanical and chemical process. RH cycling-based ADT shows that degradation comes from a mainly mechanical process. In situ fluoride release rate technology was employed to elucidate the degradation of the proton exchange membrane during the ADT. It was found that the proton exchange membrane suffered more serious damage under OCV-based ADT. The loss of F- after the durability test was up to 3.50 × 10−4 mol/L, which was 4.3 times that of the RH cycling-based ADT. In addition, the RH cycling-based ADT had a significant effect on the catalyst layer, and the electrochemically active surface area decreased by 48.6% at the end of the ADT. Moreover, it was observed that the agglomeration of the catalysts was more obvious than that of OCV-based ADT by transmission electron microscopy. It is worth noting that both testing protocols have no obvious influence on the gas diffusion layer, and the contact angle of gas diffusion layers does not change significantly. These findings contribute to understanding the degradation behavior of proton exchange membrane fuel cells under different working conditions, and also provide a scientific basis for developing more effective testing protocols.

Verification of Durability Test Methods of an MEA for Automotive Application

A Polymer Electrolyte Fuel Cell Life Test Using Accelerating Degradation Technique

Key Components Degradation in Proton Exchange Membrane Fuel Cells: Unraveling Mechanisms through Accelerated Durability Testing

Diagnosis of Membrane Electrode Assembly Degradation with Drive Cycle Test Technique

Degradation Characteristics of Membrane Electrode Assembly under Drive Cycle Test Protocol

Degradation Study of Membrane Electrode Assembly with PTFE/Nafion Composite Membrane Utilizing Accelerated Stress Technique

Evaluating the Durability of Perfluorosulfonic Acid Membranes in Fuel Cells Using Combined Open-Circuit Voltage-Accelerated Stability Testing

Quantification on Degradation Mechanisms of Polymer Exchange Membrane Fuel Cell Cathode Catalyst Layers During Bus and Stationary Durability Test Protocols

Simultaneous accelerated stress testing of membrane electrode assembly components in polymer electrolyte fuel cells

Development of Chemical and Mechanical Acceleration Stress Test Method for PEMFC Polymer Membranes

Durability degradation mechanism and consistency analysis for proton exchange membrane fuel cell stack

Electrocatalyst Durability under Simulated Automotive Drive Cycles

Methodology of Designing Durability Test Protocol for Vehicular Fuel Cell System Operated in Soft Run Mode Based on Statistic Results of On-Road Data

Investigation of Performance Degradation and Control Strategies of PEMFC under Three Typical Operating Conditions

Dynamic accelerated stress test and coupled on-line analysis program to elucidate aging processes in proton exchange membrane fuel cells

Enhancing durability of automotive fuel cells via selective electrical conductivity induced by tungsten oxide layer coated directly on membrane electrode assembly

A Review of Durability Test Protocols of the Proton Exchange Membrane Fuel Cells for Vehicle

Durability of Highly Active PGM Catalyst MEA Tested Via Nitrogen and Air AST Cycling under HDV Condition

Design of Durability Test Protocol for Vehicular Fuel Cell Systems Operated in Power-Follow Mode Based on Statistical Results of On-Road Data

Novel Analytic Method of Membrane Electrode Assembly Parameters for Fuel Cell Consistency Evaluation by Micro-Current Excitation

Aging Effects Observed in Automotive Fuel Cell Stacks by Applying a New Realistic Test Protocol and Humidity Control