Developing an Economical Wear and Corrosion Resistant Fe-Based Metallic Glass Composite Coating by Plasma and HVOF Spraying

Sapan K. Nayak,Anil Kumar,Tapas Laha

DOI: https://doi.org/10.1007/s11666-021-01277-w

IF: 2.839

2021-11-19

Journal of Thermal Spray Technology

Abstract:Recently, thermal spraying processes are receiving great attention from the research community for the development of Fe-based metallic glass (MG) composite coatings possessing unique combination of improved mechanical and corrosion properties. At the same time, selection of thermal spraying process and deposition parameters are critical, as coating characteristics including porosity and amorphicity are highly dependent on these factors, and such characteristics have significant influence on both mechanical and corrosion properties. Accordingly, in this work, two prominently used thermal spraying methods; atmospheric plasma spraying (APS) and high-velocity oxy-fuel (HVOF) spraying were employed to synthesize an economical in-situ MG composite coating system based on a newly developed FeCrBPC alloy (Fe63Cr9P5B16C7). This was done to establish a comprehensive correlation between process-microstructure-wear and corrosion resistance for Fe-based MG composite coating prepared via different thermal spraying processes. Microstructural characterization revealed lower amount of porosity and reduced amorphicity for HVOF-coating compared to APS counterpart. The HVOF-coating exhibited higher wear and corrosion resistance, attributed to the better combination of porosity content and level of amorphicity. Most importantly, both the composite coatings exhibited superior wear and corrosion resistance compared to HVOF-sprayed SS316L coating prepared using industrially optimized parameters.

materials science, coatings & films