Specific methanogenic activity test for anaerobic treatment of phenolic wastewater

Athar Hussain,Shashi Kant Dubey
DOI: https://doi.org/10.1080/19443994.2013.823116
IF: 1.1
2013-07-24
Desalination and Water Treatment
Abstract:Anaerobic processes have been successfully used in the treatment of municipal and industrial wastewater. However, the effect of nutrients like nitrogen and phosphorus on specific methanogenic activity (SMA) in anaerobic treatment of wastewaters containing phenol has not been systematically investigated. Phenol is present in industrial effluents like coal gasification, coke production, pharmaceutical, pesticide, fertilizer, dye manufacturing, synthetic chemical, and pulp and paper. This paper presents experimental study on determination of SMA using phenol as a sole substrate and the present work is being compared with the studies carried out by various researchers using different substrates. SMA test was carried out immediately after seeding the upflow anaerobic sludge blanket reactor with sludge in order to determine the initial phenol biodegradation during the start-up phase of the reactor. Anaerobic degradation of phenol to methane takes place via benzoate and then to acetate. Therefore, the SMA was determined by taking benzoate as well as acetate as substrates. The SMA of acetate was found less than that of benzoate. Therefore, for the SMA in case of phenol biodegradation the conversion of phenol to benzoate has been shown to be rate liming step. Based on the SMA test and COD removal the optimum COD:N:P ratio for anaerobic treatment of phenolic wastewater is proposed to be 300:1:0.1. Also, to increase the performance of the system and to achieve stable conditions an organic loading rate of 0.40 kg COD/m3 d was tested and resulted in 98% COD removal. This study will be very helpful in maintaining optimum organic load and COD:N:P ratio for enhanced removal of phenol from wastewater.
engineering, chemical,water resources
What problem does this paper attempt to address?