Abstract:Threaded fasteners were developed long time (let’s remember that Archimedes – 287-212 BC – invented the water screw). Nowadays, bolted joints are used in almost all sectors of the industry. But in spite of having been an important machine part for centuries, problems may be encountered with them. They are so common that they are taken for granted and too often, not analyzed as deeply as it should be. The wrong tightening is one of the most frequent causes of ductile rupture and by far the most frequent cause of fatigue failure. The tightening operation is never easy. It is necessary to pay particular attention to the choice of the tightening tool, the process and the control method. The tightening operation may itself cause damage on parts. The tightening load must not be too low, or excessive or not equally distributed among the bolts. These three defects can even be made on the same bolted joint! This impacts badly the performance of the assembly and leads to a shorter lifespan. If insufficient precautions are taken, the real tightening preload on all the bolts will not fit well with the requirements and would be badly distributed. Consequently, the practical conditions are quite different from the hypothesizes which are taken for the initial calculations (analytics or FEM) at the design stage. Thus, the results of the calculations of bolted joints cannot be considered as accurate and reliable. Practically, there are several means to tighten a bolt. The two ways most frequently used are torque wrench and hydraulic bolt tensioner. Torque wrench involves exerting a torque to the bolt head or the nut. Hydraulic bolt tensioner applies a traction load directly on the bolt. It is well known that bolt tensioners give better accuracy and homogeneity in the final tightening load than the torque method, but the tension load applied with the tensioner must be higher than the final remaining tightening load. So, the paper focusses on the hydraulic tensioner to show how the tightening load can be obtained from the applied tension load and to propose a way to optimize and secure the tightening process. However, for the reasons above mentioned it appears necessary to first make a general description of technical aspects of bolted joints. What really happens when tightening with torque wrench or with bolt tensioner is explained.

Finite Element Simulation of Process Control for Bolt Tightening in Joints With Nonparallel Contact

Analysis of Process Parameters Influencing Protuberance During Interference Fit Installation of Hi-lock Bolts

Numerical Simulation of the Assembly Process of Bolted Flange Joints Used in Rotating Machinery

Tightening performance analysis of bolted connection considering non-parallel contact

Finite element analysis of bolted joints under torsional loads

The Tightening and Untightening Modeling and Simulation of Bolted Joints

Automotive Bolts Tightening Analysis using Contact Stress Simulation: Developing An Optimal CAE Design Approach Model

High Precision Control Method Of Pre-Tightening Force For Threaded Connection Of Joining-Separation Mechanism In Aircraft

Optimal tightening process of bolted joints

Torsional and compressive properties of bolted joint under forward-reverse tightening

Semi-Physical Simulation Optimization Method for Bolt Tightening Process Based on Reinforcement Learning

Analysis and determination of bolt tightening process factors for composite structures under multiple working conditions

An Improved and Robust Finite Element Model for Simulation of Thin-Walled Steel Bolted Connections

Process modeling, joint virtual testing and construction of joint connectors for mechanical fastening by flow-drilling screws

Investigation of machine tool rigidity through measurements and FEA

Finite Element Analysis and Mathematical Characterization of Contact Pressure Distribution in Bolted Joints

Process and product-performance modeling for mechanical fastening by flow drilling screws

Effect of Bolt Clamping Force and Constraint Arrangement on Structural Strength of Bolted Joint

A New Tightening Method for Bolted Joints by the Simultaneous Application of Torque and Compressive Force

A Process-Traceable High-Precision Tightening System: System Architecture and Synchronous Control.

An improved 3D model of composite bolted joints with detailed thread structure and progressive damage analysis of realistic tightening process