Abstract:Enhancement-mode (E-mode) GaN MOS-HEMTs using recess process typically face the challenge of precise thickness control, surface roughness issue, and interface traps, all of which could lead to the degradation of the device performance and cause reliability issues. In this article, we use a combined process of atomic layer etching (ALE) technique and atomic layer deposited (ALD) HfSiO dielectric. ALE is repeated oxidation and dry etching process with minimal surface damage, leading to a precisely controlled low-damage recess channel area. The fabricated AlGaN/GaN MOS-HEMTs exhibit E-mode operation with a positive threshold voltage (V-th) of +2.1 V with small V-th dispersion for different devices, an ultrahigh drain current ON-OFF ratio over 1010 and a low ON-resistance (R-ON) of 11.5 Omega . mm at gate-to-drain length (L-GD) of 25 mu m. Source field plate (SFP) structure is employed to reduce the charge trapping process and improve the reliability at high voltages. The current collapse of the E-mode device with SFP structure can be effectively suppressed due to the optimized redistribution of the peak electric field in the gate-to-drain access region, where a significantly improved dynamic R-ON of only 1.17 times increase from the static R-ON after OFF-state V-DS stress of 600 V. Moreover, the enhanced vertical electric field with decreased AlGaN barrier thickness and the positive shift in threshold voltage for the E-mode device can effectively suppress the current collapse, which outperforms the depletion-mode counterpart. The breakdown voltage reaches a considerable value of 1560 V at an OFF-state current density of 1 mu A/mm.

The impact of a recessed Δ-shaped gate in a vertical CAVET AlGaN/GaN MIS-HEMT for high-power low-loss switching applications

Low ON-resistance and high current GaN Vertical Electron Transistors with buried p-GaN layers

Numerical analysis on the performance enhancement in AlGaN/GaN vertical CAVET with InGaN/AlN/InGaN hybrid current blocking layer

Design, Fabrication, And Performance Analysis Of Gan Vertical Electron Transistors With A Buried P/N Junction

Efficient III-Nitride MIS-HEMT devices with high-κ gate dielectric for high-power switching boost converter circuits

Study of High-Performance GaN-Based Trench CAVET with Stepped Doping Microstructure

Improving Performance and Breakdown Voltage in Normally-Off GaN Recessed Gate MIS-HEMTs Using Atomic Layer Etching and Gate Field Plate for High-Power Device Applications

Current status and scope of gallium nitride-based vertical transistors for high-power electronics application

DC and RF performance analysis of enhancement mode fin-shaped tri-gate AlGaN/GaN HEMT and MOSHEMT with ultra-thin barrier layer

All-WBG Cascode Device with p-GaN Gate HEMT and SiC JFET for High-Frequency and High-Temperature Power Switching Applications

Reverse-blocking AlGaN/GaN Normally-off MIS-HEMT with Double-Recessed Gated Schottky Drain

Improved Current Collapse in Recessed AlGaN/GaN MOS-HEMTs by Interface and Structure Engineering

823-Ma/mm Drain Current Density and 945-Mw/cm2 Baliga’s Figure-of-Merit Enhancement-Mode GaN MISFETs with a Novel PEALD-AlN/LPCVD-Si3N4 Dual-Gate Dielectric

Improvement of reverse conduction characteristic and single event effect for a novel vertical GaN field effect transistor with an integrated MOS-channel diode

Design of Enhancement Mode β-Ga2O3 Vertical Current Aperture MOSFETs With a Trench Gate

10 MHz-Switching on GaN Trench CAVET up to 300 °C Operation Enabled by High Channel Mobility

Enhancement Mode AlGaN/GaN MISHEMT on Ultra-Wide Band Gap β-Ga2O3 Substrate for RF and Power Electronics

Investigation of high threshold voltage E-mode AlGaN/GaN MIS-HEMT with triple barrier layer

Current-collapse Suppression and Leakage-Current Decrease in AlGaN/GaN HEMT by Sputter-Tan Gate-Dielectric Layer

Optimization of Gate-Head-Top/Bottom Lengths of AlGaN/GaN High-Electron-Mobility Transistors with a Gate-Recessed Structure for High-Power Operations: A Simulation Study

Performance improvement of enhancement-mode GaN-based HEMT power devices by employing vertical gate structure and composite interlayers