Abstract:Purpose The three-axis simulator relies on the air film between the air bearing and the bearing seat to achieve weightlessness and the frictionless motion condition, which is essential for simulating the micro-disturbance torque of a satellite in outer space. However, at the beginning of the experiment, the disturbance torque caused by the misalignment between the center of gravity of the simulator and the center of rotation of the bearing is the most important factor restricting the use of the space three-axis simulator. In order to solve this problem, it is necessary to set the balance adjustment system on the simulator to compensate the disturbance torque caused by the eccentricity. The paper aims to discuss these issues. Design/methodology/approach In this paper, a study of L1 adaptive automatic balancing control method for micro satellite with motor without other actuators is proposed. L1 adaptive control algorithm adds the low-pass filter to the control law, which in a certain sense to reduce the high-frequency signal and speed up the response time of the controlled system. At the same time, by estimating the adaptive parameter uncertainty in object, the output error of the state predictor and the controlled object can be stabilized under Lyapunov condition, and the robustness of the system is also improved. The automatic balancing method of PID is also studied in this paper. Findings Through this automatic balancing mechanism, the gravity disturbance torque can be effectively reduced down to 10 −6 Nm, and the automatic balancing time can be controlled within 7 s. Originality/value This paper introduces an automatic balancing mechanism. The experimental results show that the mechanism can greatly improve the convergence speed while guaranteeing the control accuracy, and ensuring the feasibility of the large angle maneuver of spacecraft three-axis simulator.

Design and implementation of attitude control algorithm of a satellite on a three-axis gimbal simulator

Attitude Stabilization of A Pico-Satellite by Momentum Wheel and Magnetic Coils

Development of a Low-Cost Satellite Three-Axis Attitude Simulator Testbed

Development of a hardware-in-loop attitude control simulator for a CubeSat satellite

Extended validation of a ground-based three-axis spacecraft simulator model

Development of a Control Moment Gyroscope controlled, three axis satellite simulator, with active balancing for the bifocal relay mirror initiative

Three-axis air-bearing based platform for small satellite attitude determination and control simulation

Research on three axis air bearing platform simulation system for small satellite attitude control

A Dynamic, Hardware-in-the-Loop, Three-Axis Simulator of Spacecraft Attitude Maneuvering with Nanosatellite Dimensions

START: A Satellite Three Axis Rotation Testbed

Mass properties identification and automatic mass balancing system for satellite attitude dynamics simulator

Three-axis attitude stabilization of a flexible satellite using non-linear PD controller

Experimental Verification of Control Strategies for Satellite Magnetic-Based Attitude Control System Under a Three-Axis Helmholtz Cage Environment

Gimbal Actuator Modeling for a Spin-Stabilized Spacecraft Equipped with a 1DoF Gimbaled-Thruster and two Reaction Wheels

A study of PID and L1 adaptive control for automatic balancing of a spacecraft three-axis simulator

Attitude Control For Flexible Spacecraft With Swinging Components

Rigid Body Attitude Control Using a Single Vector Measurement and Gyro

Automatic Mass Balancing of Spacecraft Attitude Simulators by Optimal Feedback Control

Staring imaging attitude tracking control of agile small satellite