Abstract:BackgroundThe impact of power and signal cable harnesses on the dynamic behavior of lightweight space structures has come into the spotlight in the recent past. The previous analytical modelling efforts in this area have primarily focused on either periodically wrapped beam structures or plate structures of parallel cable wrapping patterns. ObjectiveThe presented paper aims at experimental validation for an analytical model developed by the authors for cable harnessed plate structures with periodic patterns such as zigzag and diagonal. The work includes an extensive analysis of the vibration behavior of cable-harnessed plates in comparison to their host plates with no cables attached.MethodsAn energy equivalence homogenization technique is developed to model the vibrations behavior of the cable harnessed plates of periodic patterns. Experimental modal analysis is performed on cable-harnessed plates using impact hammer excitation and laser doppler vibrometry. The natural frequencies, mode shapes, and frequency response functions are obtained for comparisons with the model predictions.ResultsThe impacts of the harnessing cables on plate dynamics are modeled and compared to the experimental frequency response functions for periodically wrapped cabled plates in four different test structures. The impact of the cable wrapping directions along the length and width on the modes that experience the largest stiffening effects are clearly discussed and validated with the test results for the two major wrapping patterns, diagonal and zigzag. It is shown that for a given number of fundamental elements and cable wrapping rows along the length, the parallel pattern experiences the largest stiffening along the length followed by the diagonal and zigzag patterns respectively. Also, the twist mode was stiffened the most for the zigzag pattern and the least in the parallel cabled plate. Finally, the wrapping angle for which the torsional frequency is maximum for each of the diagonal and zigzag patterns is found to be the same. A computational study is also performed to further analyze the system dynamics by varying the host plate dimensions.ConclusionsThe model and test results are shown to be in very good agreement. The analytical model is found to well predict the cables' mass and stiffening effects for all the wrapping patterns studied in this research.

Investigation on Damping of a Host Structure Induced by Attached Cables

INVESTIGATION OF DAMPING MATRICES ACCURATE ESTIMATION OF CABLE-STAYED BRIDGES BASED ON NON-PROPORTIONAL DAMPING

Damping Parameter Identification Of Large Span Cable-Stayed Bridges

STRUCTURAL MORPHOLOGY AND DYNAMIC CHARACTERISTICS ANALYSIS OF DRUM-SHAPED HONEYCOMB-TYPE III CABLE DOME WITH QUAD-STRUT LAYOUT

A study on the aerodynamic damping of the Geiger type cable dome

Assessment of the Structural Damping Required to Prevent Galloping of Dry HDPE Stay Cables Using the Quasi-Steady Approach

Estimation of damping matrices of cable-stayed bridges based on known data of modal damping

Influence of changes of Rayleigh damping coefficient on dynamic vibration response of towed cable during rotation process in towed system

Analytical Study of Structural Conformation and Prestressing State of Drum-Shaped Honeycomb Quad-Strut Cable Dome Structure with Different Calculation Methods

Identification of Aerodynamic Damping of Cable Domes

THEORETICAL ANALYSIS AND EXPERIMENTAL TEST ON DAMPING CHARACTERISTICS OF CFRP STAY CABLES

Sensitivity Analyses of Cables to Suspen-Dome Structural System

STUDY ON CHARACTERISTICS OF MODAL DAMPING OF STEEL AND CFRP STAY CABLES

Dynamic Analysis and Experimental Validation of Periodically Wrapped Cable-Harnessed Plate Structures

EXPERIMENTAL STUDY ON VIBRATION MITIGATION OF A STAY CABLE USING NONLINEAR HYSTERETIC DAMPERS

Dynamic Behaviors of a Two‐Cable Network With Two Negative Stiffness Dampers and a Cross‐Tie

Free vibration of a taut cable with internal high damping rubber dampers and an external negative stiffness damper

Feasibility Study of the Electromagnetic Damper for Cable Structures Using Real-Time Hybrid Simulation

Vibrations Analysis of Cable-Harnessed Plates: Continuum Modeling and Experimental Validation

Wind-Induced Vibration Control of High-Rise Structures Using Compound Damping Cables

Mechanical performance analysis of large span spatial structure with tie-down vibration-reduction cable