Abstract:Predicting pressure drop in gas wells is one of the most important issues for designing deliquification technologies and optimizing gas production. Current pressure-drop prediction methods can be divided into analytical and empirical models. Although various models have been proposed to predict pressure drop in wellbores, no model has offered stable performance over wide liquid and gas flowrate ranges. Especially for gas wells with low liquid – gas ratios, very few models have been developed specifically. In this study, a simple and accurate three-point model is developed for predicting liquid holdup in wellbores. The model is based on the liquid holdups and gas velocities at the annular – churn, churn – slug and slug – bubble boundaries and is comprehensive for calculating the liquid holdup in vertical wellbores at different liquid/gas flowrates and pressures. The proposed method was verified with 39 collected laboratory and 182 field measured data points from the literature, which have wide parameter ranges. For comparison, some widely used models in the petroleum industry were also evaluated. In validation with the laboratory data with pipe diameters of 50.8 and 101.6 mm, although the new model has an average percentage error ( E 3) of 220.1% in the churn flow, ranking fourth of all the evaluated models, the other five indicators in the churn flow and six indicators in the annular flow are lowest of all these evaluated models, resulting in relative performance factors (RPFs) of 0.2 and 0, respectively. In the field measured data, gas and liquid productions range between 0.34 × 10 4 —77.6 × 10 4 m 3 /d and 1—347.8 m 3 /d, tubinghead pressure ranges from 0.7 to 84.7 MPa, which can cover most gas wells. The validation demonstrates that the new model still has good performance with five indicators being lowest. The RPF of the new pressure-drop model in the field measured data ranges is 0.29, still lowest of all these evaluated models, showing better performance than these widely used models in petroleum industry for vertical gas wells. This indicates that the new model can accurately predict pressure drop under different conditions in vertical gas wells.

A New Comprehensive Model for Predicting the Pressure Drop of Flow in the Horizontal Wellbore

The Pressure Drop Model of Liquid Flow with Wall Mass Transfer in Horizontal Wellbore with Perforated Completion

A simple and accurate model to predict pressure drop in vertical gas wells

Theoretical Approach for the Calculation of the Pressure Drop in a Multibranch Horizontal Well with Variable Mass Transfer

Construction and application of flow pressure drop model of perforated well considering pressure loss of perforation hole

Mathematical Modeling of Heat Transfer and Pressure Drops in the Single- and Dual-Pipe Horizontal Wells

A New Model for Predicting Liquid Loading in Shale Gas Horizontal Wells

Experimental and Modeling Investigation on Gas-Liquid Two-Phase Flow in Horizontal Gas Wells

A New Way to Calculate Flow Pressure for Low Permeability Oil Well with Partially Penetrating Fracture

A Differential Pressure Sensor Coupled with Conductance Sensors to Evaluate Pressure Drop Prediction Models of Gas-Water Two-Phase Flow in a Vertical Small Pipe

Model and Analysis of Pump-Stopping Pressure Drop with Consideration of Hydraulic Fracture Network in Tight Oil Reservoirs

Pressure drop prediction model of the gas-liquid stratified flow development section in the horizontal pipeline

New revised correlation to predict pressure drop for oil-gas two-phase flow through horizontal pipe

Study on the Pressure Drop Variation and Prediction Model of Heavy Oil Gas-Liquid Two-Phase Flow

Mathematical Model and Constitutive Formulations for Frictional Pressure Drop of Oil-Water-Air Three-Phase Flow in Horizontal Pipes

Cuttings-liquid frictional pressure loss model for horizontal narrow annular flow with rotating drillpipe

Improved calculation models for penetration ability of deep-penetrating horizontal perforation technique with self-induced nozzle bit

Pressure Drop of Variable Mass Flow in Perforation Completion of Horizontal Wellbore

A Multiparameter Coupled Prediction Model for Annular Cuttings Bed Height in Horizontal Wells

Experimental investigation on flow patterns and pressure gradients of shale oil-water flow in a horizontal pipe