Abstract:<p>As it is usually operating in bad working conditions and subjected to the severe interference from diverse paths, internal faults of the hydraulic valve are difficult to be detected using conventional hydraulic testing technology (such as relying on pressure sensors or flow sensors). Moreover, the information collected from a single sensor may not provide accurate diagnostic evidence or a complete description on faults of hydraulic valves, even though employing intelligent fault diagnosis methods. Therefore, a two-stage multi-sensor information fusion method is proposed, including the fault feature fusion and the decision-making information fusion. The aim is to realize the diagnosis on internal faults of hydraulic directional valves using the vibration signal analysis method instead of conventional hydraulic testing ones. The method is mainly divided into three steps. First, the noise reduction of the vibration information collected by multiple acceleration sensors is done using ensemble empirical mode decomposition (EEMD) and Teager-Kaiser energy operator (TEO), so that fault features are more obvious. Then, multi-class fault features including the severity and the location of the wear are extracted from the preprocessing signals to form the original feature set. Second, combined with feature ranking and subset selection based on euclidean distance (FRSSED) and maximum relevance minimum redundancy (mRMR) feature selection method, the statistical features extracted from multiple sensor signals are optimized to form the optimal feature subset. This is the first-level information fusion concerned with fault feature information fusion. In the third step, based on Dempster-Shafer (DS) evidence theory and convolutional neural network (CNN), decision-making information is fused (called second-level information fusion) to obtain the final diagnosis results. A hydraulic test bench is built to test different failure valves. Experimental results indicate that this method is effective in extracting the fault features from multi-sensor signals and detecting the fault states including severity and location of internal wear of the hydraulic valve.</p>

Hydraulic cartridge valve group reliability evaluation and fault diagnosis based on data and model integration

New Design of the Control System for Hydro-Viscous Clutch

A Fault Detection Method for a Practical Electro-Hydraulic Variable-Displacement Pump with Unknown Swashplate Moment.

Modeling and Analysis of Hydraulic Controlled Rotary Valve Excitation System

Mathematical model and experimental verification of high flow cartridge servo valve

Design and control of the hydraulic reciprocating pump

Analysis and Diagnosis on Internal Leakage in Electro-Hydraulic Quick-Control Regulating System of Steam Turbine

EXTENDED DISTURBANCE OBSERVER-BASED SLIDING MODE FAULT-TOLERANT CONTROL FOR THE DUAL-VALVE HYDRAULIC SERVO SYSTEM WITH REDUCED-ORDER MODEL

Automatic Testing and Control System for Electro-Hydraulic Proportional Displacement Pump Based on LabVIEW

The Design of Low Cost Valve-and-pump Compounded Pressure Control System for the Hydro Viscous Clutch

Investigation into the Independent Metering Control Performance of a Twin Spools Valve with Switching Technology-controlled Pilot Stage

Quantitative Fault Diagnostics of Hydraulic Cylinder Using Particle Filter

Modeling and Parameter Sensitivity Analysis of Valve-controlled Helical Hydraulic Rotary Actuator System

Simulation Study On The Control Valve In Hydraulic Operating Mechanism Of The High Voltage Circuit Breaker

A Novel Current-Based Identification Method for Dynamic Performance of High-Speed On/Off Valve

Optimal design of cartridge check valve control unit in a multi-pump hydraulic system

Fault Simulation and Diagnosis of High Speed Hydraulic Operating Mechanism of High Voltage Circuit Breakers

Fault diagnosis in a hydraulic directional valve using a two-stage multi-sensor information fusion

Multisource Electrohydraulic Servo Valve Fault Status Diagnostic Algorithm Based on a Message Propagation Mechanism

An Intelligent Fault Diagnosis Approach Based on Dempster-Shafer Theory for Hydraulic Valves

Construction machinery hydraulic transmission system fault analysis and elimination methods