Abstract:Amorphous alloys owing to their high hardness, strength, corrosion and wear resistance are regarded as one of the potential coating materials for applications in severely corrosive environment. A high-velocity-oxygen-fuel (HVOF) spraying process was employed in this study to prepare an amorphous Fe alloy coating on SUS316 substrate. The prepared Fe40-Cr19-Mo18-C15-B8 alloys had high hardness but the micro-structural examination showed micro-voids and micro-cracks permeated in the coating. Both x-ray diffraction (XRD) and transmission electron microscopy (TEM) measurements confirmed the combined amorphous and nano-crystalline phases in the coating. Thermal stress after cooling from the spray process caused the emergence of intensive cracking. The potentio-dynamic polarization curves of the prepared coating were measured in four different solutions, respectively: 0.5M H2SO4, 1M NaOH, 3.5wt% NaCl, and seawater. Among them, the prepared coating had better corrosion resistance in neutral solutions. The corrosion tests under different applied over-potentials in seawater further revealed nearly ten-fold increase in corrosion current when the over-potential was raised from -100 mVSCE, +200 mVSCE, +600 mVSCE, to +800 mVSCE, respectively. Although the coating surface roughened considerably at higher over-potentials, oxidation of Mo and Cr elements in this Fe alloy during corrosion test, confirmed from the measured six-valenced ions of Mo6+ and Cr6+ in the x-ray photoelectron spectroscopy (XPS) analysis, was beneficial in lowering the corrosion current.

Synergistic Effect of Mo, W, Mn and Cr on the Passivation Behavior of a Fe-Based Amorphous Alloy Coating

Electrochemical Corrosive Behaviors of Fe-Based Amorphous/ Nanocrystalline Coating on Stainless Steel Prepared by HVOF-Sprayed

Corrosion Resistance, Composition, and Stratification of Passive Films: Ni-22Cr and Ni-22Cr-6Mo Alloys Passivated and Exposure Aged in Acidic Chloride Solutions

Molybdenum effects on the stability of passive films unraveled at the nanometer and atomic scales

Morphology and Anti-Corrosive Performance of Cr(III) Passivated Zn-Fe Alloy Coating on NdFeB Substrate

Corrosion and mechanical behavior of amorphous-nanocrystalline NiCrMo coatings

Sensitivity of Corrosion Behavior for Fe-Based Amorphous Coating to Temperature and Chloride Concentration

Effect of Mo on microstructure, mechanical and corrosion properties of FeCrNiMnMox high-entropy alloys

Corrosion resistance of Fe-based amorphous metallic matrix coating fabricated by HVOF thermal spraying

Passivation of Ni-Cr and Ni-Cr-Mo Alloys in Low and High pH Sulfate Solutions

The effect of Mn addition on corrosion behaviour of equiatomic CoCrFeNi high entropy alloys in NaCl solution

Reactive molecular dynamics simulations of the initial oxidation and passivation of Fe-Cr alloy steel

Effect of WC-10Co-4Cr Reinforcement Amount on Wear and Corrosion Resistance of Fe-Based Amorphous Coatings

Corrosion of high-velocity-oxygen-fuel (HVOF) sprayed non-crystalline alloy coating in marine environment

Microstructure and corrosion behavior of Cr and Cr–P alloy coatings electrodeposited from a Cr(III) deep eutectic solvent

Corrosion Resistance and Passivation Behavior of CoCrFeNi-TiAl High-Entropy Alloy Coatings in Acidic Solutions

Effect of annealing on corrosion resistance and mechanical properties of Cr–Fe–Ni–Co–Mo–Si–B amorphous coating

Effect of Mo Addition on Corrosion Behavior of High-Entropy Alloys CoCrFeNiMox in Aqueous Environments

Microstructures and corrosion resistance of Fe-based amorphous/nanocrystalline coating fabricated by laser cladding

Study on the repair behavior of passive film of iron-based amorphous coatings by eco-friendly phosphate inhibitors

Corrosion Performance of Fe-Based Amorphous Coatings via Laser Cladding Assisted with Ultrasonic in A Simulated Marine Environment