Nondispersive Infrared Gas Analyzer for Vapor Density Measurements of a Carbonyl-Containing Organometallic Cobalt Precursor

James E. Maslar,William A. Kimes,Brent A. Sperling,Ravindra K. Kanjolia
DOI: https://doi.org/10.1177/0003702817716939
2017-07-14
Applied Spectroscopy
Abstract:A nondispersive infrared (NDIR) gas analyzer was demonstrated for measuring the vapor-phase density of the carbonyl-containing organometallic cobalt precurso μ 2 -η 2 -( t Bu-acetylene) dicobalthexacarbonyl (CCTBA). This sensor was based on direct absorption by CCTBA vapor in the C≡O stretching spectral region and utilized a stable, broadband IR filament source, an optical chopper to modulate the source, a bandpass filter for wavelength isolation, and an InSb detector. The optical system was calibrated by selecting a calibration factor to convert CCTBA absorbance to a partial pressure that, when used to calculate CCTBA flow rate and CCTBA mass removed from the ampoule, resulted in an optically determined mass that was nominally equal to a gravimetrically-determined mass. In situ Fourier transform infrared (FT-IR) spectroscopy was performed simultaneously with the NDIR gas analyzer measurements under selected conditions in order to characterize potential spectroscopic interferences. Interference due to CO evolution from CCTBA was found to be small under the flow conditions employed here. A CCTBA minimum detectable molecular density as low as ≈3 × 10 13 cm −3 was calculated (with no signal averaging and for a sampling rate of 200 Hz). While this NDIR gas analyzer was specifically tested for CCTBA, it is suitable for characterizing the vapor delivery of a range of carbonyl-containing precursors.
spectroscopy,instruments & instrumentation
What problem does this paper attempt to address?