Abstract:The Cu materials are playing an irreplaceable role in modern marine facilities, while one major issue affecting their service life is corrosion attack caused by external erosion of chloride ions, which leads to the quickly structural deterioration and reduced durability. To solve this obstinate issue, the corrosion−resistant Ni−based composite films with conductive Yttria–stabilized zirconia (YSZ, 2.5–15 g/L) and non−conductive Si 3 N 4 (2.5–15 g/L) reinforcing phases were composite–electrodeposited on Cu substrate in direct current (DC) mode. It was believed that the electrical differences of incorporated nanoparticles have a significant impact on nucleation and growth behaviors during electrodeposition, which further altered the structure and property of Ni−based composite films. Therefore, the emphasis of this study was to establish the correlation between obtained structure, electrochemical, and immersion corrosion performances at different incorporation levels of YSZ/Si 3 N 4 nanoparticles. The results demonstrate that by increasing the total doping contents, the Electrochemical Impedance Spectroscopy (EIS) and Chronoamperometry (CA) measurements exhibited an initial increase followed by a subsequent decrease on co−deposition dynamics, which was related to the dominant impact of conductive YSZ nanoparticle at electrocrystallization process. Meanwhile, the moderate incorporation level of 15 g/L offered effective control over structural compactness through dispersion−strengthening and grain−refining, and the same ratio of YSZ/Si 3 N 4 nanoparticles further maximized the improvement degree of microhardness, electrochemical passivation, and immersion stability of resulting films. Besides, the corrosion current density ( j corr ) of Ni−YSZ−Si 3 N 4 composite coating under optimum condition of 15 g/L was two orders of magnitude smaller than that of Cu substrate after long−term immersion test, and the corresponding polarization resistance ( R p ) also increased by 8.6 times. Overall, these substantial alterations obtained provide effective guideline for the design and preparation of corrosion−resistant Ni−based composite coating, which is beneficial to prolonging the service life of Cu components in saline environments.

Electrochemical Deposition of Ni-Co/SiC Nanocomposite Coatings for Marine Environment

Fabrication and performance of Ni-Co-P/Si3N4 electroplated composite coatings on al-si alloys

Electrochemical Properties and XPS Analysis of Ni-B/SiC Nanocomposite Coatings

Electrodeposition and Characterization of Nano-Structured Ni–SiC Composite Films

A Study on the Electrocodeposition Processes and Properties of Ni–SiC Nanocomposite Coatings

Enhanced mechanical and wear properties of Ni-W-SiC composite coatings by synergistic influence of micro-nano SiC mixture

Electrodeposition of High-Quality Ni/SiC Composite Coatings by Using Binary Non-Ionic Surfactants.

Investigation on corrosion resistance of electroless Ni-W-P coatings co-deposited with SiO2 nanoparticles

Electrodeposited FeCoNiWMo high entropy alloy/SiC nanocomposite coatings: Microstructure, mechanical properties and corrosion resistance

Sediment co-deposition of nanostructured Ni-Al2O3 composite coatings

Investigation on Microstructure and Properties of the Electrodeposited Ni-SiC Composite Coating

Study on Preparation and Properties of Nano Ni-SiC Amorphous Composite Coatings

Electrodeposition fabrication of corrosion−resistant Ni–based composite film on surface of Cu: Role of conductive YSZ and non−conductive Si 3 N 4 nanoparticles

Nucleation and Growth Mechanism of Ni/SiC Composite Coatings Electrodeposited with Micro- and Nano-Sic Particles

Electrochemical Behavior of Electroless Ni-P-SiC Nano-Composite Coatings

Electrodeposition of Ni-Co-Fe 2 O 3 Composite Coatings

Preparation, Mechanical Properties and Wear Resistance of Ni–W/SiC Nanocomposite Coatings

Comparative study on the wear resistance and corrosion resistance of NiW and NiCoW composite coatings with micro- and nano-SiC particles

Fabrication and Characterization of Ni-Al2o3 Nano-Composite Coatings by Sediment Co-Deposition

Preparation of Chromium Carbide-Strengthened Ni-W Coatings by Electrodeposition and the Corresponding Anticorrosion Behavior in CO2-Saturated NaCl Solution