Abstract:Groove surface textures with different orientations and spacings were prepared on the Ti–6Al–4V alloy by using a laser. Fretting tests (rubbed with a Ti–6Al–4V ball) were conducted under different textures, and the coefficient of friction (COF) curves, system deformation and wear morphologies were analysed in detail. The groove orientations to the fretting direction affected the fretting wear behaviour through the following ways: (1) Fretting tests on different groove orientations resulted in different fretting loop shapes at the initial stage of fretting wear. (2) The COF curves of fretting test on perpendicular grooves and 45° grooves were similar. COF presented a sharp increase after approximately 1000 cycles under relatively low loads. The COF curves of fretting test on parallel grooves and untextured surface were similar. Only a small oscillation of COF was observed during the whole fretting tests. (3) When fretting was run in gross slip regime, the magnitude of system deformation was perpendicular grooves, no-texture samples, 45° grooves, and parallel grooves in order. The above results may have resulted from the influence of surface textures on the formation and development of wear debris. For the perpendicular grooves, high pressure was recorded in partial slip regime cracks, and peeling appeared on the convex platform of samples with the groove spacing of 80 μm, and this phenomenon promoted the formation of debris. Moreover, the perpendicular grooves prevented debris from spilling out of contact areas. For the parallel grooves, the filling mechanism of grooves was found, in which the material in the upper layer gradually squeezed the material in the lower layer toward the centre and bottom of the groove, and the parallel grooves accelerated debris from spilling out of contact areas. Therefore, groove surface textures may adjust the fretting regime of titanium alloys by changing the orientation and spacing, which could provide a new tribology design for fretting friction pairs.

Effect of groove surface on friction noise and its mechanism

Effects of grooved surface texture on friction noise

The effect of groove-textured surface on friction and wear and friction-induced vibration and noise

Experimental investigation of friction noise on lubricated contact

Squeal Noise of Friction Material With Groove-Textured Surface: An Experimental and Numerical Analysis

Effect of surface contact conditions on the stick–slip behavior of brake friction material

Friction-Wear and Noise Characteristics of Friction Disks with Circular Texture

Influence of Groove Surface Texture on Temperature Rise under Dry Sliding Friction

Effect of surface roughness on friction-induced noise: Exploring the generation of squeal at sliding friction interface

Vibration and Noise Behaviors During Stick–Slip Friction

Effects of Single/Compound Pit Texture on the Friction-induced Vibration and Noise of Thrust Cylindrical Roller Bearings

An approach to correlate friction-induced noise with coefficient of friction

Experimental investigation of frictional noise and surface-roughness characteristics

Influences of Two Micro/Nano-Particulates on Friction and Noise Properties of Diurea Grease

Tribological mechanism of micro/meso/macroscopic textured surfaces under different normal forces, relative velocities, and sliding directions

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Tuning of friction noise by accessing the rolling-sliding option

Effect of groove surface texture on the fretting wear of Ti–6Al–4V alloy

Frictional Characteristic Curves of Ground Surfaces in Lubricated Sliding

Contact and Tribological Study of Micro/Nano Groove Texture on the Surface of Gas Bearing Materials Based on Nanoscale

Effect of Surface Grooves on the Static Friction of an Elastic Slider