Abstract:Nanocrystalline zinc oxide (ZnO) samples are synthesized through a facile hydrothermal route at different temperatures. Sample synthesized at 80 °C (sample code HT80) has average crystallite size of 32 ± 2 nm and the morphology is not unform with the presence of rods, wires and discs. Sample prepared at 160 °C (sample code HT160) has rod-like morphology with an average crystallite size of 130 ± 5 nm. X-ray photoelectron spectra reveal the presence of hydroxyl groups bonded to Zn 2+ , oxygen vacancies and adsorbed oxygen species in both the samples. Atomic percentage of the bonded/adsorbed hydroxides and oxygen containing species is higher in HT80. Band gaps values are lower in comparison with bulk ZnO due to band bending. Photoluminescence spectra has a UV peak at ∼381 nm (3.25 eV) and a broad emission band in the visible region centred at ∼550 nm (2.25 eV) respectively corresponding to the band edge emission and defect mediated emission. The emission profile of both samples is similar indicating the presence of similar type of native point defects viz., Zn vacancies, Zn interstitials and oxygen vacancies in different charge states. Sample HT160 has more intense emission due to the better photonic absorption. The photocurrent response under wide light irradiation is also larger for HT160 with a sensitivity of 37 due to the better photonic absorption and larger crystallite size. Wavelength dependent photocurrent response for this sample shows highest sensitivity at 380 nm with a sensitivity of 152 corresponding to the band-to-band excitation. A weak photoresponse for visible light irradiation (∼600 nm) due to the desorption of adsorbed O 2 or hydroxide species caused by the direct photoexcitation of the captured electron to the conduction band is also noted. Photocatalytic efficiency of both the samples are comparable with rate constants 3.1 × 10 −2 min −1 and 3.7 × 10 −2 min −1 respectively for HT80 and HT160. The reusability is much better for sample HT160 which is attribute to larger average crystallite size and uniform morphology.

Efficient diagnostics of the electronic and optical properties of defective ZnO nanoparticles synthesized using the sol–gel method: experimental and theoretical studies

Surface Topography and Optical Properties of Al-doped ZnO Thin Films by Sol-gel Process

The effects of intrinsic defects on the structural and optical properties of ZnO thin film prepared via a sol-gel method

Synthesis, characterization and LDA+U calculations of zinc oxide nanoparticles

Effect Of Nitrogen And Intrinsic Defect Complexes On Conversion Efficiency Of Zno For Hydrogen Generation From Water

Disordered ZnO nanoparticles with extremely intense deep-level emission and enhanced photocatalytic activity

Structural and Optical Analysis of 1D Zinc Oxide Nanoparticles Synthesized Via Hydrothermal Method

Defect engineering for enhanced optical and photocatalytic properties of ZnS nanoparticles synthesized by hydrothermal method

Investigation on the Structural and Optical Properties of ZnO Thin Films Prepared by Sol-Gel Method

Engineering of Optical and Electrical Properties of ZnO by Non-Equilibrium Thermal Processing: the Role of Zinc Interstitials and Zinc Vacancies

Photoluminescence, photocurrent response and photocatalytic activity of hydrothermally derived nanocrystalline ZnO with native point defects

Normality Effect on Characterization of Chemically Synthesized ZnO Nanoparticles

Probing size-dependent defects in zinc oxide using synchrotron techniques: impact on photocatalytic efficiency

A comparative study of optical, reversible wettability and UV light sensitivity of ZnO nano-structures via chemical methods

Ab-initio, Monte Carlo and experimental investigation on structural, electronic and magnetic properties of Zn1-Ni O nanoparticles prepared via sol-gel method

X-ray peak broadening and strain-driven preferred orientations of pure and Al-doped ZnO nanoparticles prepared by a green gelatin-based sol-gel method

Ni-doped ZnO nanoparticles derived by the sol–gel method: structural, optical, and magnetic characteristics

Probing defects in chemically synthesized ZnO nanostrucures by Positron Annihilation and Photoluminescence Spectroscopy

Identification of Defect-Related Emissions in ZnO Hybrid Materials

Sol-gel synthesis, characterizations of efficient Y3+ doped ZnO nanoparticles for photocatalytic dye degradation and energy storage applications

The synthesis of novel ZnO microcrystals through a simple solvothermal method and their optical properties