A Model for Subsurface Oil Pollutant Migration

Mohamed Hayek
DOI: https://doi.org/10.1007/s11242-017-0926-9
IF: 3.6097
2017-09-18
Transport in Porous Media
Abstract:The subsurface spill of hydrocarbon fluids (from an underground leaking tank or from pipelines) is a widespread problem in the oil industry and hydrology. Under the assumption of low oil saturation, the migration of oil pollutant may be modeled by a nonlinear convection–diffusion equation with power law nonlinearities. The saturation-dependent diffusion coefficient is proportional to a power of saturation for which the exponent may be negative or positive depending on the porous medium and the pollutant characteristics. This paper presents general analytical solutions for the one-dimensional transient saturation distribution in immiscible zone. The solutions describe the longtime behavior of a contaminant oil pollutant caused by a continuous source of contaminant (e.g., leakage from pipelines, disposal dumps or storage tanks). Two general forms corresponding to positive and negative power exponents of the diffusion coefficient are presented. The general forms express implicitly the position as function of oil saturation and time. An alternative explicit closed-form solution near the front position is also proposed. An exact explicit solution is obtained for the particular case of constant diffusion coefficient. The proposed solutions are fully analytical in the sense that they do not require any numerical implementation. The solutions may be used to study the porous medium and pollutant parameters. They can be applied to aquifer contamination problems, and they are also important for the verification of numerical solutions.
engineering, chemical
What problem does this paper attempt to address?