Abstract:The hardness, tensile ductility and fatigue lifetime of nanostructured (NC) Cu–Zr alloyed thin films have been systematically measured at different Zr additions (0, 0.5, 2.0, 4.0, 8.0at.%). Experimental results showed that the Cu–0.5at.% Zr film exhibited the highest hardness, largest ductility and longest fatigue lifetime, which are increased by 120%, 80%, and above an order of magnitude, respectively, in comparison with its pure Cu counterpart. The simultaneous improvements of mechanical properties are rationalized with respect to microstructural evolutions related to Zr segregation at grain boundaries (GBs). Besides refinement in NC grains and enhancement in nanotwins, grain orientation was apparently modified by the GB Zr segregation. (110) grains were promoted and layer-like microstructure was formed with coexistence of three orientation of grains at the upper layer, facilitating Cu grain growth at room temperature. GB doping strengthening worked as an additional strengthening mechanism and mechanically driven grain growth became the predominant deformation mechanism and fatigue mechanism, which accounted for the optimal combination of mechanical properties achieved in the Cu–0.5at.% Zr film. When the Zr content was >2.0at.%, however, amorphous phases were formed at the GBs due to locally increased Zr concentration. The GB doping strengthening effect was concomitantly weakened and strength was gradually decreased. In addition, stress/strain localization occurred readily at the amorphous phase regions, triggering intergranular fracture and reducing ductility. During cyclic testing in the low stress range, GB amorphous phases strengthened rather impaired the GBs, which gave the Cu–Zr films a fatigue lifetime greater than that of the pure NC Cu film. The present results clearly indicate that, once solute content is suitably explored, the solute segregation at GBs in NC metals can not only retain NC grains in loading-free conditions, but also impart enhanced mechanical properties when exposed to applied stress.

Influence of Asymmetric Cyclic Loading on Structural Evolution and Deformation Behavior of Cu-5 at.% Zr Alloy: An Atomistic Simulation-Based Study

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Micro-scale mechanism for cyclic deformation behavior in Zirconium under low-cycle-fatigue loading

Hot Deformation Behavior and Microstructure Evolution of a Novel High-Zn Containing Al-Zn-Mg-Cu-Zr Alloy

Deformation mechanism of fine grained Mg–7Gd–5Y–1.2Nd–0.5Zr alloy under high temperature and high strain rates

Microstructure and mechanical properties of extrusion ZC61 alloys under different dynamic compression loading directions

The effect of loading methods on the microstructural evolution and degree of strain localization in Cu50Zr50 metallic glass composite nanowires: A molecular dynamics simulation study

Microstructural Evolution, Mechanical Properties and Deformation Mechanisms of Nanocrystalline Cu Thin Films Alloyed with Zr

Room-Temperature Strengthening, Portevin-Le Chatelier Effect, High-Temperature Tensile Deformation Behavior, and Constitutive Modeling in a Lightweight Mg-Gd-Al-Zn Alloy

Dynamic Properties of Low-Alloyed Copper Alloys with Submicrocrystalline Structure Obtained by High Strain Rate Deformation

Investigation of the microstructure and properties of extrusion-shear deformed ZC61 magnesium alloy under high strain rate deformation

Synergistic effects of temperature and strain rate on tensile properties of simulated Ni-6Cu alloy with Σ3 non-Arrhenius grain boundary

Dynamic compression behaviour and microstructural evolution of the Mg–6Zn–2Ce–0.6Zr alloy

Investigation on deformation mechanisms of Zr-1Sn-0.3Nb-0.3Fe-0.1Cr alloy using in situ EBSD/SEM

High strain rate compression deformation mechanism and constitutive equation of fine grained Mg–7Gd–5Y–1.2Nd–0.5Zr alloy at different temperatures

Structural mechanisms of enhanced mechanical properties in amorphous–nanocrystalline ZrCu alloys under irradiation

Effects of deformation parameters and stress triaxiality on the fracture behaviors and microstructural evolution of an Al-Zn-Mg-Cu alloy

A Study of Stress-Induced Phase Transformation and Micromechanical Behavior of CuZr-based Alloy by In-Situ Neutron Diffraction

A Molecular Dynamics Simulation to Shed Light on the Mechanical Alloying of an Al-Zr Alloy Induced by Severe Plastic Deformation

Strain-Rate-Dependent Deformation Behavior of Ti29Zr24Nb23Hf24 High Entropy Alloys at Elevated and Room Temperature

Experimental and numerical analysis of cyclic deformation and fatigue behavior of a Mg-RE alloy