Effects of Coil Diameter in Thickness Measurement Using Pulsed Eddy Current Non-destructive Testing

Khairun Nisa Azaman,Ali Sophian,Faris Nafiah

DOI: https://doi.org/10.1088/1757-899x/260/1/012001

2017-11-01

IOP Conference Series: Materials Science and Engineering

Abstract:Non-destructive testing (NDT) techniques are used in industry to evaluate the properties of a material, component or structure without causing any permanent damage. Among the techniques, pulsed eddy current (PEC) NDT is regarded as a new technique where a broadband pulse excitation is used, as opposed to single frequencies employed in conventional eddy current NDT. In this study, a 2D axisymmetric electromagnetic model of a PEC probe has been developed and it has been used to study the effects of the excitation coil diameter on the performance of PEC probes in sample thickness measurement. A PEC system has also been built to validate the model. Aluminium plates are used as the sample and they can be stacked up to replicate thickness from 1 mm to 10 mm. The results show that there is a very good correlation between the simulation and experimental results, with an average error of less than 10%. The results also suggest that the larger the diameter of the excitation coil, the deeper the penetration and therefore the larger the thickness measurement range. It has also been shown that although the larger diameters have deeper penetration, the smallest diameter has the highest sensitivity if normalization is not used. These conclusions indicate that coil diameter is an important parameter in a PEC probe design for thickness measurement applications.

English Else