Abstract:Controlling the properties of nano-sized copper oxide (CuO) is an interesting approach for broadening its multifunctionality. This paper reports the deposition of CuO thin films on ultrasonically cleaned glass substrates. The sol–gel spin coating technique was employed to prepare un-doped films with different thickness, Ni-doped and (La, Ni) co-doped CuO films in the formulas; Cu1−xNixO (0 ≤ x ≤ 0.06) and Cu0.94−yNi0.06LayO (0.02 ≤ y ≤ 0.06). The structural and morphological properties were studied by X-ray diffraction (XRD), Fourier transformation infrared (FTIR) spectroscopy, and atomic force microscopy (AFM). The optical and wetting properties were investigated by UV–Vis spectrophotometer and water contact angle (WCA) measurement, respectively. XRD and FTIR results confirm the synthesis of nanostructured CuO of monoclinic structure. The average crystallite size, D, is dependent on the number of the coated layers of the pure CuO film. The value of D increased from 22.2 nm for the four-layered CuO film to 24.2 nm upon the incorporation of 6 % Ni content. Then, it decreased to 11.4 nm after the co-doping with 6 % La. Ni doping improved the (002) preferential orientation and La co-doping reduced the crystallinity of the films. The films are hydrophilic and their wetting properties were enhanced by increasing the film thickness and La incorporation. Ni and La co-doping could efficiently control transmittance, optical band gap, and the refractive index of the films. The existence of stable copper oxide films at room temperature with band gaps around 2.0 eV supports their use in catalysts and gas sensing applications as well as in optoelectronics and solar technologies.

Preparation of Copper-Doped Nickel Oxide Thin Films by Sol-Gel Method Using Nickel and Copper Acetate

Synthesis and Characterization of Un-Doped and Copper Doped Nickel Oxide Thin Films

Preparation and Properties of NiO Films Via Sol-gel Process and Spin-coating

The effect of copper doping on the structural, optical, and electrical properties of nickel oxide thin films for optoelectronic applications

Preparation and Characterization of Na-doped ZnO Thin Films by Sol–gel Method

Impact of copper doping in NiO thin films deposited by spray pyrolysis on their physical properties

Structural, morphological, optical properties and wettability of spin-coated copper oxide; influences of film thickness, Ni, and (La, Ni) co-doping

Enhancement of Visible Light Emission of Ni-Doped ZnO Sprayed Thin Films by Copper Co-Doping

Carbonaceous Nickel Oxide Composite Films with Homogenously Dispersed Metallic Ni Nanoparticles by a Facile Sol–gel Method

Annealing Effects on the Microstructure and Photoluminescence Properties of Ni-Doped Zno Films

Nickel Oxide Films Deposited by Sol-Gel Method: Effect of Annealing Temperature on Structural, Optical, and Electrical Properties

Electrochromic and Electrochemical Properties of Nickel Oxide Thin Films Prepared by a Modified Sol-Gel Method

Electrical and optical properties of sol–gel-deposited NiO films and corresponding response to annealing temperature

Preparation of nanometer NiO powders doped Li+ by a sol gel method and its conductivity

Sol-Gel Preparation of Ag/ZnO Films and Their Electrical and Optical Properties

Investigation of structural, morphological, and optical properties of (Ni/Co, Fe/Co, and Fe/Ni) co-doped ZnO thin films prepared by sol-gel spin coating technique

Study on P-Type Nickel-doped CuO Transparent Conductive Films Prepared at Room Temperature

Preparation and Properties of Ni-Si-O Thin Film Prepared by Sol-Gel Method

Impact of annealing temperature on the structural, morphological and optical properties of Ni doped ZnO nanostructured thin films synthesized by sol–gel methodology

Study of Annealing Effect Upon the Structural and Solar- Selective Properties of C/Ni/NiO Composite Coatings Prepared by Sol–gel Method

The prospect of spray pyrolyzed pure, Mn-doped, and Zn-doped nickel oxide thin films as TCO material