Abstract:Abstract The use of low transformation temperature (LTT) filler materials represents a smart approach for increasing the fatigue strength of welded high strength steel structures apart from the usual procedures of post weld treatment. The main mechanism is based on the effect of the low start temperature of martensite formation on the stress already present during welding. Thus, compressive residual stress formed due to constrained volume expansion in connection with phase transformation become highly effective. Furthermore, the weld metal has a high hardness that can delay the formation of fatigue cracks but also leads to low toughness. Fundamental investigations on the weldability of an LTT filler material are presented in this work, including the characterization of the weld microstructure, its hardness, phase transformation temperature and mechanical properties. Special attention was applied to avoid imperfections in order to ensure a high weld quality for subsequent fatigue testing. Fatigue tests were conducted on the welded joints of the base materials S355J2 and S960QL using conventional filler materials as a comparison to the LTT filler. Butt joints were used with a variation in the weld type (DY-weld and V-weld). In addition, a component-like specimen (longitudinal stiffener) was investigated where the LTT filler material was applied as an additional layer. The joints were characterized with respect to residual stress, its stability during cyclic loading and microstructure. The results show that the application of LTT consumables leads to a significant increase in fatigue strength when basic design guidelines are followed. This enables a benefit from the lightweight design potential of high-strength steel grades.

Microstructure and fatigue properties of friction stir welded high-strength steel plates

Microstructure evolution and high cycle fatigue failure behavior of friction stir-welded Ti–6Al–4V at varying welding speeds

Fatigue Crack Growth on Flash Butt Welded and Laser Beam Welded Joints in a High-Strength Low-Alloy Steel

High-cycle rotating-bending fatigue performance of S690QL welded joints

Some issues of fatigue failure of welded structures

Friction stir welding of high-strength steel

Fatigue of Friction Stir Welded Aluminum Alloy Joints: A Review

Undermatched Welding of Ultra-High-Strength Steel S1100 with Metal-Cored Wire: Influence of Welding Positions on Mechanical Properties

Fatigue analysis of the friction stir welded AA6061-T6 aluminum alloy

Residual Stress, Microstructure and Mechanical Properties in Thick 6005A-T6 Aluminium Alloy Friction Stir Welds

Fatigue Strength Assessment of Friction Welds under Consideration of Residual Stress

Mechanical properties and microstructural evaluation of the heat-affected zone in ultra-high strength steels

Microstructure and Mechanical Properties of Friction Stir Welded 2205 Duplex Stainless Steel Butt Joints

Fatigue resistance characterization of frictions stir welds between complex aluminum extrusions: An experimental and finite element study

Microstructure and Corrosion Properties of Friction Stir-Welded High-Strength Low -Alloy Steel

Insights into microstructure evolution and fracture mechanisms of welded joints of high strength steel patchwork components

Effect of processing temperatures on the properties of a high-strength steel welded by FSW

Study on fatigue behavior of butt-welded high-strength steel connections with surface cracks

Capability of martensitic low transformation temperature welding consumables for increasing the fatigue strength of high strength steel joints

Microstructure and fatigue performance of friction stir welded joints of 2A12‐T4 and 7075‐T6 dissimilar aluminum alloy

Welding of S1100 Ultra high‐Strength Steel Plates with Matching Metal‐Cored Filler Wire: Microstructure, Residual Stresses, and Mechanical Properties