Influence of post-synthetic treatments of aluminum-rich ZSM-5 on the catalytic cracking of bulky hydrocarbons at low temperature

Xuan Hoan Vu,Thanh Tam Truong,Udo Armbruster,Andreas Martin
DOI: https://doi.org/10.1007/s11144-017-1317-5
2017-11-18
Abstract:The influence of post-synthetic modifications of Al-rich ZSM-5 (Si/Al ratio ca. 10) involving alkaline and subsequent acid treatments on the textural, acidic and catalytic properties in the cracking of bulky hydrocarbon molecules at low temperature is reported. It was found that the optimized base treatment, i.e. 0.5 M NaOH should be used for the substantial generation of intracrystal mesoporosity while preserving the intrinsic zeolite properties of ZSM-5 zeolite. A subsequent strong acid washing, i.e. 0.5 M HCl is required to completely remove Al-rich debris formed during the base treatment, thereby improving the textural and acidic properties. The catalytic performance of the parent and treated ZSM-5 materials was evaluated in the gas phase cracking of 1,3,5-triisopropylbenzene (TIPB) and cumene as test reactions. The results showed that under the applied cracking conditions, the introduction of mesoporosity by the optimized base–acid treatments on the one hand increased the accessibility of Brønsted acid sites, producing a higher TIPB conversion (82.5% as compared to 61.9% of the parent ZSM-5), on the other hand, it promoted the transformation of pre-cracking products, leading to a higher selectivity to deep cracking products, i.e. the selectivity of cumene and benzene of 22.7% as compared to 17.6% of the parent ZSM-5. A similar conclusion has been reached in the cracking of cumene where the presence of considerable mesoporosity indeed improved cumene reactivity of the alkaline and acid treated ZSM-5 as its density of strong zeolite Brønsted sites was mainly retained.
What problem does this paper attempt to address?