Electrocatalytic Reduction of Nitrate and Nitrite at CuRh Nanoparticles/C Composite Electrodes

Peyman Mirzaei,Stéphane Bastide,Atieh Aghajani,Julie Bourgon,Claudia Zlotea,Michel Laurent,Michel Latroche,Christine Cachet-Vivier
DOI: https://doi.org/10.1007/s12678-017-0437-z
2017-11-17
Electrocatalysis
Abstract:Composites consisting of rhodium, copper, and copper-rhodium nanoparticles (2 nm in average diameter) dispersed in a high-surface area graphite powder (~ 10 wt.% of metal) have been synthesized by a wet chemical method. After characterization by ICP-OES and TEM, they have been tested for the electrochemical reduction of nitrates in alkaline media (10−1 mol L−1 KOH) using a cavity microelectrode. It is found that in the 0.02–0.5 V/RHE potential range, bimetallic composites exhibit a much higher electrocatalytic activity than single-metal composites. The peak current describes a volcano plot as a function of the composition, with a maximum for CuRh, which is 7.5 times higher than that obtained with pure rhodium (under identical metal wt.%). This synergistic effect can be rationalized directly from the electrochemical response of pure metals. It is then tentatively attributed to the fact that the first (rate determining) reduction step, corresponding to the formation of nitrites, takes place efficiently in copper-rich areas while the subsequent steps of nitrite reduction in ammonia (via hydroxylamine formation) occur in rhodium-rich areas. For the same mass of rhodium, the electrocatalytic conversion of nitrates to ammonia is 12 times more effective with CuRh than with pure rhodium. With the additional gain in active surface area due to the nanoparticle morphology compared to bulk or thin film forms, these results represent a step-forward in cost reduction of rhodium-based electrocatalysts for the conversion of nitrates to ammonia.Graphical AbstractComposites of copper-rhodium nanoparticles in graphite powder were tested for the electrochemical reduction of nitrates in alkaline media. They exhibit a much higher electrocatalytic activity for the conversion of nitrates to ammonia than composites with pure rhodium nanoparticles, up to 12 times more at a composition close to CuRh.
chemistry, physical,electrochemistry
What problem does this paper attempt to address?